Brass Y Shut Off Valve, 3/8" Hose Barb 3 Way 2 Switch Y Shaped Ball Valve with 3 Hose Clamps

Used to connect 2 propane bottles to the generator in order to switch to a full tank if one runs empty. Each tank has its own regulator and this is connected at the low pressure side. Works fine

Great quality all metal piece. Nice snug fitting. Used with 1/2 inch drain hose. Highly recommended!

I used this valve as a diverted after installing two flush clean-outs on the black water tank of a travel trailer (one on the front sensor side and one on the back of the tank). The valve is decent quality, though the item showed up with some bent barb connections, like it had been dropped. I was able to easily straighten them out with a screwdriver. The clamps that came with the valve would not tighten completely and kept popping out of the clamp. For my application, this is not much of a problem, but will need better hose clamps for higher pressure applications. The valve is smooth and appears to be decent quality for the price.

Works good. No frills 3 way connector. I used mine to add a reserve fuel tank to my boat. No, I didn't run out of gas, but I had to help someone that did and thought this might be a good preventive measure to make sure that I DON'T!!!!

These fittings have caused me a slight bit of headache in for my application. I purchased 2 25' rolls of 3/8" id hose from home depot and lowes. It took a lot of muscle to force the hose onto the barb, but I thought that would be good for a good tight fit and seal. Well, it ended up stretching the hose to its breaking point, cracking the hose resulting in water leaks or busting out completely. So I tried again, same result. I began to look into what size this actual barb was and found it is significantly bigger than 3/8". I shouldn't have gone with the cheapest one on the market. Currently I've drilled out my hoses a little wider, and we'll see what happens next. I have a feeling I'm going to have to buy all new valves.