GDSTIME 60mm x 15mm Fan 3 Pin, 12V Brushless DC Cooling Fan 60x60x15mm for PC Cases, CPU Coolers, and Radiators (2 Pack)

Great airflow. The description didn’t say it came with nuts and bolts, so that was a pleasant surprise that saved me a trip. I have them running at full speed, and the noise is minimal; there’s a quiet hum, but I’m using it for a 3D printer, which is louder, so it’s not really a problem. If you want a completely silent fan, you’re gonna have to pay a little more.

I have an old HP pavilion computer from 1999 with a 533mhz Celeron processor. Someone had actually thrown it away and I brought it home. One man's junk is another man's treasure they say. The computer was pretty dirty and from a smokers house. If you know you know. Cleaned it up quite nicely, gave it a needed HDD. The fan on the cpu was packed with crud and wasn't spinning well. Cleaned up the heatsinks and reapplied some cheap thermal paste.This is the new fan I used to replace the old one. After 2 weeks in, I been playing around with it quite a bit and everything works great. Only needed one fan but they ship and sell as a 2 pack. Anyway, haven't had any noticeable issues so 5 stars from me.

Strong, Powerful but Pretty Loud.. They're good fans with good airflow. Just noisy and affordable with two a pack.

these are nice little 3 pin fans. I got them for a SFF build but unfortunately they didn't fit, however I have tested them because I will eventually find a project for them. For a small SFF case, these actually move a decent amount of air considering that they are not pwm and they just have 1 speed they are almost whisper quiet. For the amount of heat generated by my little system these would have been exceptional for removing that heat and encouraging airflow. They feel well balanced too, I didn't notice any abnormal vibration in them when running so that bodes well for longevity of the bearing. They were also pretty cheap so this is a win.

Used these to replace the fans on a Netgear switch. They are much quieter but push less air. Original fans were 0.18A, these are 0.08A but temps seems to be just fine!I did have to switch the + and - which was as easy as pulling them out by force then reinserting them in the connector in the order I wanted.

These fans are not quiet, and have no rubber vibration dampening. Overall, a bad buy and I replaced with something better.

Had a i7 processor in my HTCC overheating because of lack of air flow in the cabinet. If the computer were used somewhat heavily it would overheat and shut down. Ordered a 80mm fan and installed it. Very quiet and have not had any overheating problems since the fan was installed. Fast shipment good value.

I needed a very slim fan for my Hyte Revolt 3 top fan. This one works great it has a strong and quiet motor. It really pulls the hot air out well. The quality is typical for a fan. It comes with a grill, and installation is pretty easy; you can plug it into a 4pin cable. I consider this a great upgrade at a very minimal cost worth every dollar.