Rhino 4200 Heat Shrink Tube Tape 1/4" 6mm Replacement for Dymo Rhino 18051 Heat Shrink Labels Compatible with DYMO Industrial Label Maker 5200 5000 6000 | Black on White | 4-Pack

I just finished using several of these cartridges for rewiring/upgrading our HOA Clubhouse sound and IT systems. I generated the labels using a Dymo Rhino 4200 labeler(another 5 start review to follow). Having retired I don't have access to my former employer's Brady labelers. The product is excellent and far more economical than Dymo's equivalent product. The Brady equivalent is even more expensive. Lettering is sharp and durable. If you haven't used heat-shrink wire labels before try shrinking them by heating on the opposite side of the lettering. Then tighten in up if needed on the letter side. This will make a tight wrinkle free label every time unless the label was too big to begin with. 1/2" works perfectly on standard CAT5 cable. With some of the thicker shielded CAT6's and above you might want to go to 3/4". Shrink wrap labels 1" and below will not fit over any connector.

Overall, I have not been disappointed with with the Aonomi labels or heat shrink tubes. So, begs the question, when is good, good enough. For me, when value meets your needs without compromise. Highly recommended.

Using these w/ Rhino 4200. They fit well, print well and shrink well. Solid product.

I have purchased close to 100 of these cartridges for a large job over the last 6 months. They work well but are a little thinner than the Dymo brand heat shrink labels. This means that they tear easily in Panduit and around sharp edges. Be careful where you use them. The price is considerably better than genuine Dymo and even better yet than Brady brand heat shrink labels.

EXCELENTE

These work fine in my cheap Dymo 160 printer. I had no idea heat shrink was even an option with it. They tend to jam if you don’t pull a little extra out when you first load it. Print quality is great and they can fit over a connector and still shrink up tight. I’ve been Putting a clear shrink tube over the top to ensure the numbers don’t wear off.

You have to give them a little time to dry or the ink can sometimes smudge. They worked great for me for everything 14ga and under. Some 14ga have thicker insulation and won't fit, but mine did. They shrink real well too and will snug up to wires you wouldn't expect.

As an industrial control systems integrator, I constantly use my Rhino label maker for marking wires and cables in the field. The high cost of the Rhino heat-shrink labels was just an unfortunate expense to the projects. I am pleased that these labels give me a cost-effective option to the Rhino products. I have found that they are as good as the Rhino product. Note, that the material is slightly softer than the Rhino labels, and thus it actually shrinks a little bit faster when the heat-gun is applied.

Always ordering these

This product worked perfectly in my Labelwriter 450 Duo, which isn’t commonly known to work with heat shrink tubing.

Es gibt nichts zu beanstanden. Funktioniert problemlos mit den günstigsten Label-Writern, welche diese Art der Kassetten verwenden...

Used these as replacement for the originals. Seem to work fine, also outside under UV exposure. Happy with it so far.

Waste of time, the print rubs off the heatshrink very easily rendering this product not fit for it's purpose. Dont waste your money. buy the real thing instead.