KCH19 Double Layered & Padded Carrying Zipper Case with Wrist Strap Use for Handheld Multimeter,Phase Indicator,Thermometer, Calibrator,Clamp Meter

Product is exactly as described. One compartment holds my substantially-sized Mastech 8268, its test leads, and 5 replacement fuses. The other shorter depth compartment holds my AST silicone test lead kit with its test probes, large alligator clips, smaller alligator clips; my Klein NCVT-3; and the Mastech manual. The pouch overall dimensions are 8 x 5 x 3 with the one compartment for my multimeter is 1.75" deep, the other 1.25" deep. Now my multimeter, its accompanying test leads, and my test lead kit along with the non contact voltage tester and fuses are in one spot and all together. I'm glad that I got this size KCH19 versus the smaller ones. It's perfect!

This is an excellent case and a perfect fit for my Fluke 115. Plus the manual and extra probes. Nice sturdy zipper, lots of padding, and looks great on top of it all. I highly recommend!

Large enough for most DMMs and probes. Meter is retained via a Velcro strap that has no elastic so you can't just slip it out any back in. Leaving the meter in is not going to work for most meters, and even if it does work with your meter, the case tends to close on it's own. All that is done for the probes is a separate pocket. No wire management is included. However is it inexpensive and tough, good enough for the price.

This is a nice small internment case with two separate compartments. I am using it to store a DMM and it's test leads, which it's a nice fit for. It could be used for other applications, such as small tools, or such. I have a couple of similar cases I use for other DMMs, and they too are similar and have worked fine for this application...

Nice construction with room for both documentation and test unit. I used mine to hold notes in the front pocket, along with a data cord, and in the larger pocket, I keep a simple meter and a set of leads. Plenty of room for everything. The padding is nice and thick, so this should keep my meter from getting banged up in my tool kit. Carry handle is a nice touch as it allows me to secure the case to the inside of my tool kit with a snap ring so it does not fall out and get lost even if my tool kit should get turned over. It would also make it a bit more secure to someone walking by and simply nicking it, they will have to at lease stop long enough to un-clip it from my bag.

I received this case yesterday and immediately used it to store my recently purchased VSTM OBDII Vehicle ECU Power supply, and my Solar Battery and charging system tester. it has two zippers that separate the two areas that I am using to store my gadgets. I used a Sharpie to write on the yellow portion what was inside the case. It fits everything perfectly ans seems to be very well made; only time will tell.

This is exactly what I needed. It has 2 compartments. The top (small area compartment) I use for my extra wires for my Digital Volt Meter. The second compartment holds the DVM and my wires.

Seems to be well built. Only time will tell. Top compartment holds leads or papwework with elastic hold down, while main compartment holds most digital meters with velcro tie down. 7 1/2 inches by 5. 'Bout 3 1/2 inches deep.

Very good case. It's in two halves independently zipped. Bottom half for the meter and the top half for the leads and clips etc. Nicely padded and seems well made. Can't get much better than this for the price and it arrived from China in around 7 days. Good news all round.Don

Nice item

Good case

Perfect for storing my Fluke 179 & 87v. Great second compartment for leads, probes and clips.Delivered very fast from China to the UK. Recommend this product and service.