Introduction If your MacBook no longer charges or you don't see the little orange or green charging light when it's plugged in, check the cord for signs of damage. In this guide we will change the cord connecting the charger to the MacBook. Alternatively, you can use this guide to repair your existing cable instead of replacing it. Follow this super helpful guide,way faster and fewer steps,you know how to do it. 【http://bit.ly/2mRwtrz】 Compatible with MacBook Air A1435 A1465 A1436 A1466 MD223 MD224 MD231 MD232 MD592 MD711 MD712 MD760 MD761 MacBook Air (11-inch, Early 2015) ; MacBook Air (13-inch, Early 2015) ; MacBook Air (11-inch, Early 2014) ; MacBook Air (13-inch, Early 2014) ; MacBook Air (11-inch, Mid 2013) ; MacBook Air (13-inch, Mid 2013) ; MacBook Air (11-inch, Mid 2012) ; MacBook Air (13-inch, Mid 2012),MacBook Air 11" 13" inch from End 2012 Tools required: A decent soldering iron Wire cutters Desoldering pump A big heavy-duty spudger A pair of snap-ring pliers for use with external snap-rings. Really any long-nose pliers would do, this is just perfect for the job if you happen to have a pair :-) Super glue 1 or 2 small clamps Be careful not to touch any of the capacitor leads, or you may receive an electric shock. Use only ESD-safe pry tools. Do not use metal pry tools or screwdrivers. You might want to wear gloves so as not to get excess super glue on your fingers. Clamp the casing together and give it a few hours for the glue to set. Just like new! When your charger is back.
H**K
VERY WEAK MAGNET, Fraudulent item picture, awful actual strain relief doesn't fit case
Fraudulent listing!!! Not as pictured. Horrible, ugly, less functional strain relief than pictured. Does not, even vaguely, match external look of original Apple strain relief. If you are choosing this for its pictured strain relief DONT BUY THIS.The magnet strength is much too weak, nothing like original, and not as strong as another Chinese knock off 45W PS I just got from amazon. So weak it falls off with the sligthtest cable bump or rub.What I received was super cheap, bad weak magnet, UGLY and wrong fitting strain relief.Again DO NOT BUY ANYTHING from this seller. He's a cheat.
K**S
Exactly as described and surprisingly easy to install.
Exactly as described and surprisingly easy to install. Pre-soldered leds were a nice touch.Tools used: metal splurgier, needle nose pliers, box cutter, soldering iron, epoxy, c-clamp.
B**Y
Works like a champ
Exactly as described. Works like a champ! I didn't completely disassemble the power brick. I split it open just enough to pull the retainer/strain relief from the shell and cut the existing wires at the retainer. I then stripped, soldered and heat shrunk the existing wires to the new cable wires.
R**A
Works
So far so good
M**Y
Faulty
Soder on wires wouldn't melt to board
Trustpilot
3 days ago
1 day ago
