DCVAMOUS 2PC 5x100 5x112 Hubcentric Wheel Spacers (NOT Adapter) 15mm with 14x1.5 Extended Bolts (40mm Shank Cone Seat) Compatible with Audi VW 5 Lug for A3 A4 A6 A8 S4 S6 S8 Golf Jetta Passat GTI

After a severe wheel wobble, I had my mechanic inspect the vehicle. He found what appeared to be a bent wheel hub, after replacing the bearing and hub, that wheel still wobbled. He then discovered the spacer itself was not flat causing my camber and toe to move in and out as the wheel rotated. Crap wheel spacers. With the stress from the spacer not being flat, the hub centric lip on the spacer broke off. This is a 3D printed wheel spacers as well, meaning they are not created with strength in mind. Heat may have caused the spacer to warp or the spacer may have just been manufactured incorrectly. Wheel spacers should be billet, meaning made from one solid piece of aluminum and lathed to its desired size and construction. 3D printing wheel spacers is for show or for wheel fitment purposes ONLY.Do not drive on these wheel spacers. They are unsafe and in the long run, not worth the money. YOU GET WHAT YOU PAY FOR.

Product seems to be of decent quality but does not fit my 03 GTI despite what the description says. The recess for the hub is not machined(or cast?) deep enough to fit flush against the mounting surface. For anyone who may not notice this during install, it could cause some serious issue or harm. As stated in other reviews, the included lugs seem to be fairly low quality belatedly on the threads and finish.

lugs seem really good quality but there was a weird rust spot in the threads of all of them in the same exact place. threads are all smooth though. Socket side of the lug is very well made/shaped. these are 10x better than my ecs tuning spacers. spacer its self is . . well. . a spacer. hub bore fits nicely. Not too much play but enough for me to know they wont be stuck on in a few weeks. nothing really to complain about so far.

These spacers and bolts fit well on the front of mk4 vw golf/Jetta, but the way the hub hole is bored at a taper, it does not allow the spacer to fit tightly against the rear hub, and would be totally unsafe to use

Didn’t come with the lug bolts :/

There did the job they needed to do because the person that sold me the wheels did not correctly identify the offset.Some of the lugs showed some oxidation on the threads even though they are brand new and were installed the afternoon they arrived.I also am a little concerned that they may stretch. time will tell.

Only received the studs… no wheel spacers!

Good quality