Edition:1 Pcs Product parameters: 1, the output capacity: Continuous current 12A, short-time current 15A (less than 10 seconds) 2, Power input: Section Section 5-9 2-3 lithium battery pack or NiMH / NiCd battery packs 3, BEC Output: 5V / 2A (linear regulator mode -Linear mode) 4, the throttle signal frequency range (Refresh rate): 50Hz-432Hz 5, Maximum speed: 2-pole motor 210000 rev / min, 6-pole motor 70,000 rev / min, 12 pole motor 35,000 rev / min 6, Size: 26mm (length) × 16mm (width) × 8mm (H); 7, Weight: 6g (including heat sink) 8 Throttle range: Automatic 9, low-voltage protection threshold: 2.7V / Section 10, the low voltage protection mode: a flexible power down 11, the brake setting: no brakes 12, start setting: Normal 13, PWM frequency: 8K Product Specifications: Tarot 12A mini power transfer (including BEC) × 1
F**4
Be careful with this
This speed control is advertised to use with 3 cell batteries. Don't do it. I ran my 2304 motor for only a few seconds and the speed control overheated and shut down. It also shut down the BEC. It's a good thing I didn't get my plane in the air or it would have been a disaster. I came home and hooked it up with a 2 cell battery and it worked fine but didn't have enough power to fly the plane. Frankly I wouldn't use it for anything.
J**7
Small and light weight with BEC.
It’s not a bad little ESC. I’m using it for a small airplane. It’s perfect for that. Maybe 3 servos. I always come back to check my comments. Seen a lot of questions about a beep menu. there isnt one. as far as i can tell. there is no low voltage cut off. timing is set to auto. and no brake. all you can do is calibrate the throttle.
D**N
Works well for me.
I test ECSs on motors that I've wound myself and this one works just fine. I tested the BEC by stalling 3, 9 gram servos at once with the motor running. No brownouts. I'll buy more.
Z**R
Once more, thank you China.
This is clearly described here and EVERYWHERE you find it online, including Ebay, as outputting 2A through the BEC, even though it's clearly printed on the item "BEC 1A@5V". Not really knowing what I was doing I purchased this, and now it sits here worthless. GOT ME AGAIN, CHINA. Crooks.
B**R
Weak BEC
This speed control did not work for my application. It was being used for a small foamy and the BEC could not support 3 sub micro servos. Whenever all moved at the same time it shutdown and reset. I can not recommend for use when the BEC is required
O**
Yes
Yes
B**O
Great small RC Airplane brushless ESC.
I find this Brushless ESC perfect for my RC Aircraft. It is lightweight, small footprint, and adequate power for the receiver. I plan to start using this on all of my small (sub 250 grams) airplanes.
Trustpilot
1 month ago
1 month ago
