Rubber Grip

Nice quality rubber grip for Mossberg Shockwave. Finger bump is properly located. Removing the bird head grip makes it so much easier to install. Soak in boiled water for 5 minutes with a little soap. Pull grip on by putting your thumb under each side, back and forth, pulling on each side under it finally wiggles on. Fit is excellent and will not come off. Better than using tactical grip tape and cheaper. Looks cool. Great value. Would definitely recommend 👍

This rubber sleeve fit perfectly over my shotguns birds head grip. The grip will help in preventing your hand from slipping. ***Use caution when installing this sleeve. Remove your birds head grip from the firearm, then begin stretching the sleeve on from the front to the back of your grip. Note the rectangular side markers on this sleeve should be at the back of your grip. Continue to work it slowly around toward the rear. When you see white stress marks in the rubber while pulling, move to another area to stretch and pull to prevent damage.

Works great and pretty easy to install. I boiled it in some water on the stove to soften it up and it took a little wok to get it positioned right but it was fairly easy to install. The grip has to be unscrewed and removed to install. It’s one bolt, easy enough.

Works well had to watch video to install. Partial disassembly of stock is required

Great addition! Easy to install (after removing the handle) and feels great in the hand.

Perfect fit on my Mossberg 500E using the Shockwave.

Pain to get on, but once it's on its not going anywhere.

Tight fit, ☺️ installation needs coaxing for some , creativity for others.🤔Will see how it works in use over time