XYgdhqpt SFATB33N01A for Technics Turntable Part - Dust Cover Hinge Fits for ...

Great Replacement for the Original Technics Hinge. Works just like the original. I suggest you watch a YouTube video on removing the original hinge to avoid breaking the turntable base. Highly recommend this as a replacement.

Will this work on a SL3300 yes with a little modification as the rivet/bolt is just a little too long As well as a crooked construction , the metal piece is slightly off on on side and rivet sits crooked It implied multiple in order as in two Needing two as it should be a set but no you get just the one for 18$

Excellent now the dust cover works the way it should

These claim to fit the Technics SL-220 turntable, but they will only if you modify them to fit. The seller should make this modification if they're going to claim they fit this turntable. Using a shorter rivet would solve the problem. These dust cover hinges use rivets that the hinge (and the dust cover) pivots up and down on. The hinges withe the rivets sticking out each side have to fit into slots on the back of the Technics SL-220. On the back, there is a pair of plastic tabs at each side that these metal hinges must slide between. If the rivet is too wide -- which it is -- you can't squeeze the hinges into the plastic slots or you might break them. Not a smart design. The solution is to use a metal file to file down each end of the rivet. Don't wear through them all the way or the rivet will come loose. But you can take off a lot of metal -- on the head of the rivet until the head is nearly flat. That will shorten the rivet just enough to slide the hinge between the two plastic tabs down into the slot that holds the hinge. A bit annoying, but the hinge does hold the cover up.

Everything about this is perfect except for the fact that the rod that the hinge pivots on is secured with a rivet whose head is about 1/8 inch too wide for the enclosure (probably due to the rounded head instead of having a flat head). The hinge does NOT fit the Technics SL-B2 due to this issue.

This hinge worked perfect and was super easy to install. Now my turntable dust cover stays open as it should.

Works perfectly on my old Technics SLD212 cover. Also I noticed that this hinges plastic support is beefed up in thickness to hopefully prevent any future cracking from the spring pressure. Great job! That was the main fault/weakness to these hinges.

Didn’t fit sent back for refund

This took a little while to cross the Atlantic and pass UK customs. It is nicely made but the rivet size means it is wider than the original part. 30 minutes of ‘fettling’ in which I filed both sides of the rivet were needed to fit it to my SL-D2. Once in place it works perfectly so was a good way to prolong the life of my turntable.

A bit too wide to fit in my SL-D3 turntable. I filed the ends and was able to squeeze it in but it is forcing the plastic a bit Note also that the hinges are sold separately so if you need 2 of them buy 2. This seems obvious but I assumed it was a set of 2 hinges and made 2 separate orders.