Iron on Oak Veneer Edging Tape 50mm x 5m

Excellent product and easy to use

Good quality.

Easy enough to cut, but you will have to cut it to fit a standard worktop.Goes on easy with an iron and seems very well stuck for the time being.The colour is a on the light side - we'll just about get by with it where we've used it (as the shadows and lighting do us a favour), but if your worktops are anything other than light oak, you should probably look elsewhere.

We have a door frame that has been adjusted by the previous owners. The door frame is now slightly smaller than a standard size door.We recently replace our doors with some cottage style American White Oak veneer doors. The door we needed were between two sizes so we had to go with the bigger size and take about 22mm of the sides. The door only had a 10mm veneer on each side so we took about 8mm off one and the rest of the other leaving the hinge side minus its veneer.We ordered this with the hopes of improving the finish of the door but it far surpassed our expectations. Once sanded and oiled you couldn't even see it.Don't be shy with the iron. Crank the heat right up and go up and down about 30cm sections at a time applying plenty of force for 30 seconds to a minute per section. I didn't do it for as long to start with but it started to lift.

it did the job although some has started to peel away in places

Absolutely fantastic product, trimmed it with scissors to 1mm wider than the door edge, used old travel iron to melt it on (no burns or changes to the oak finish) carefully trimmed excess with a sharp blade sanded it smooth

It was easy to apply but I must admit I placed while my wife used the iron, it may be a bit more fiddly doing on your own. Looks good finish is great.

This product was easy to apply with a hot iron and looked great when on. It matched the oak top perfectly.