6203-RS Sealed Bearing - 17x40x12 - Lubricated - Chrome Steel (4 PCS)

My hayward 1.5hp pump motor blew the front bearing. A new motor is about $260. A whole new pump is closer to 1K. I was able to buy these bearings and quickly and cheaply repair the old motor. I did need to use a bearing puller to remove the old ones. These new ones fit perfectly after being lightly hammered into place. I tested the motor on the bench with 115V and it sounds pretty quite. This motor will go on the shelf as a my "new" backup motor in case the one I swapped it with dies, so it may be a long time before I know how long these bearings lasts. The original motor lasted 9 years. The original part number I replaced was 62032RS and they cost $17.07 a piece, so these were a much cheaper option.

I got this bearing(JVB 6203rs or 2rs) for a Rikon 10-325 for the upper and lower wheels. Rikon wheels come with 4 of these bearings with a 5/16 spacer.I accidentally ordered JSB 52032rs . This bearing and the original bearing fit the wheels exactly with no spacer which is much easier to press in without the spacer.So you need two of each bearing and it works perfectly.Bearings are tight and you probably have to press them in.

My old 1/2 hp motor runs like new! Smooth and quiet. Total rebuild for peanuts compared to the gawd awful price for new. So surprised how easy it was.

Good bearings, easily installed.

Bearing works good.

Used to replace a bad idler bearing for my Datsun 260z A/C compressor.

Great they fit.

My Kubota L2850 had a bad water pump and while I had it apart, I noticed that the bearings on the fan support were binding up, too. The fan utilizes 2 bearings, back to back... these were a perfect fit and relatively easy swap.