15 FT Rail Mill Guide System 3 Pairs of Aluminum Profiles with 6 Nail Components

Item as described

If only using one section, this is a great little saw guide. Putting three of them together to make a 15' guide is a nightmare. Components are far too flimsy for such a length. It takes forever to get them level and then keeping them level throughout the cut is nearly impossible.

I have yet to get it completely put together but I already am imagining retrofitting and adding a few key elements to enhance the stability of the product

Package damaged and parts missing

I'm using the 3 sections to make 15 feet and I'm having issues. The leveling screws will vibrate out; the solution I used was to wrap with Teflon tape or use different screws. Keeping the 5' sections joined tight, flat and level is difficult. there is a small piece of steel that screws into place to hold together but there has to be a better way to make this more sturdy. It's so nice being able to take this apart for transport and storage and different uses but if you are going to use 15' maybe consider while it is still brand new and you get it lined up perfectly and level, find a way to securely and permanently put them together. It's still supper light weight and can be stored anywhere you store your long lumber or ladder. Perhaps the best solution would be a better system for the joint. A longer, perhaps a 1 foot long 3 or 4 sided piece of steel that fits to join the sections together with 3 or more recessed screw points to hold that in place.

Good rail system, very accurate

Absolutely worthless I wish I didn't waste my money. The threads for the leveling screws are tapped with way to much slop. And the m8-1.25 set screws just wiggle out while your cutting. Not to mention you will have to custom order set screws since amazon doesn't carry the oversized 6 inch or 4.5 inch screws. Don't waste your money.

Works with my mill. Easy to set up and use. Storage is easy as well.