Boat Flooring Mat EVA Foam Boat Decking Marine Carpet Faux Teak Sea Decking Sheet Non-Slip Self-Adhesive Flooring Material for Pontoon Yacht Surfboard Swim Platform RV Floor 94" x 35"

I used this to replace the seating pads on my classic Hobie wave. The key? "Cleanliness is next to godliness" I always say! I removed the old pads, in my case they were able to be removed complete in one piece. Its easy enough to use the old pad as a pattern, I marked spots on the patter to align the gaps on either side of the seat. I cleaned the rinsed the surface and re-glued the caps that are underneath the pads first. I then cleaned the surface using 99% Alcohol pads until nothing else would wipe off. Then I peeled and stuck the pads and trimmed with X-Acto knife. This product stuck well enough that I struggled trimming even small amounts because they were stuck so well. After one day in the hot sun, the ends seemed to curl up some, I had not gotten them wet yet, so I just pressed them back down and placed some weight on the curled edges. The next day they were tight and right and have not peeled anymore. I am going to say this product works well and give it a thumbs up!

After several near misses and finally actually slipping and falling into the lake, I decided I needed to do something about the surface of my boat’s swim deck. When I received the product, it wasn’t quite what I was expecting. I was expecting a more rubber material, but this pretty much foam, not very rubbery. I was concerned it might not be very durable, and might need some additional adhesive to make it stick. So far, my concerns have been unfounded. If you clean the surface well (I used acetone) it sticks down quite well on its own. You can cut complex shapes with a razor blade, and I found it to be tough enough to dull a razor blade pretty quick. Seems to withstand shoed foot traffic surprisingly well, but it’s still early yet. I used a couple strips of it on my boat trailer fenders too. I’m sufficiently impressed with it that I’m considering re-doing the entire boat floor with it, but I’m going to wait a while and see how it holds up on the swim deck. The traction improvement is significant, and it provides a little cushion too, which is nice when kneeling.

The product was very easy to install and looked great for the first month or so and then the product separated from the adhesive as you can see by the pictures the adhesive is still on my boat but separated from the product should not be called decking for boats I have the same problem on my swim platform and on the outside deck in the cockpit area I'm going to contact the company about paying to remove the adhesive from my boat and refund me for the product as you can see in the pictures the adhesive sticks great on the fiberglass but the adhesive does not stick very well to the product.

Works great but need to take time installing and trimming

Looks as good as the expensive custom made ones at a fraction of the price. I made custom borders to my install to make it look a lot better and more of a custom look. Takes some time to do but in the end, the results are amazing. Like others have mentioned, They do start to peel off after a while. I suggest you use the 3M Spray adhesive or similar during installation so that it holds better.

Great quality

The self-stick back does not adhere well.

Really easy to work with.. had to order two sheets.. at different times.. one came just a hair darker.. so if you need 2 or more sheets order at the same time.. maybe they'll come off the same roll..I was sticking it to an all aluminum deck that had been prepped and wiped down with mineral spirits, which seemed to help really make it stick.. rolled it out with the wife's rolling pin..Like I said, time will tell.. but I think it looks great!!If you're contemplating on buying this over another choice.. get this one.. I'd buy again