Mophorn Hydraulic Pump, 10 Quart Hydraulic Power Unit, Single Acting Hydraulic Pump, 12V DC Hydraulic Pump (Steel Reservoir, Single Acting, 3200 PSI) w/SAE#6 Connector for Dump Trailer Car Lifting

Arrived packaged well with no shipping damage. Simple install. Battery positive connects to the large solenoid post (see photo, red cable), battery negative connects to the large post on the backend of the motor (see photo, black cable). The fitting adapter that came with replaces the installed fitting, it fits into the pump outlet and accepts a -6 JIC Female swivel. The pressure relief valve on this one ( the pressure setting screw is the lower one) was fully out and required loosening the lock nut and a metric Allen wrench to turn it in, I needed to turn it completely in to the stop to achieve full pressure and then tightened the lock nut and reinstalled the cap nut for the adjustment screw. The upper screw is for setting the flow allowed when the lowering solenoid is active (this is used to adjust how fast the hydraulic fluid is allowed to return to the reservoir and requires the same metric Allen wrench, turning it in slows the flow). The switch pendant work fine, I will be installing a weather proof connector ito the side of the box to allow easier access with the box closed and locked. So far I have loaded the dump bed with 5 large loads in excess of 8000 lbs and the pump unit had me issues supplying enough flow and pressure to lift it quickly and smoothly. My system has a 3.25 inch cylinder (see the video). At max pressure had no leaks or seepage at the pump unit. I did add a fitting to the tank to accept a 3/8 inch rubber line from the dead end of the cylinder but a simple breather/filter would also work just fine.

Works great

I would not recommend for heavy duty use/ dirty conditions. Worked okay for a few months although slower than the hydraulic unit that came with my trailer originally. I had motor issues shortly after. I’ve seen some people say they aren’t sealed up well and get moisture and dirt in the motor. I’m assuming that’s my issue.

I purchsaed this pump for a 12 foot tilt trailer that had a valve on the ram going port to port a manual setup. I read a lot of reviews and I was worried about a lot of people having problems with trying to find some non standard British fittings. It came in the box with 4 fittings. I removed the ones in the pump replaced them with the other provided. I made two hoses up for exact fit. Everything I used was power steering ram fittings. Welded a piece of flat bar 2"x3/8 8" long to the frame for mounting. I bolted the pre threaded pump block with M10-1.5x35MM to the welded flat bar. The the port coming out of the relay valve with the red knob on it is the pump (up) button and the other side of the block is the the (down). I adjusted the pump so it would not over pressure up or down, so it would bypass at a reasonable pressure. It lifted 2800Lbs with ease. The unit was properly prewired. All of the electrical stud contacts had to be torqued. Be carful the isolated relay contactor is a cheaper one but sufficient for the load. I Used two number 2 wire with no voltage drop at 3' long. Pump is fast. I installed some baffles on the hoses at A-B outputs to tame it down little. I dont think the solenoid and relays are water proof. If this thing will be exposed to weather I would build a cover over the pump electronics. I have only ran it 30-40 times to soon to tell if it will last. Good design well made product for the money. Unit came packaged good.

Ok so wiring diagram is indeed confusing... we just hooked up positive to the pole on the pump that says positive and negative to negative. But its in and seems to b working well the last couple weeks... hopefully it will stay that way... can't tell longevity of course but so far so good.

Ok

How can I get it to drop a little bit faster?Mind goes down slow

Just perfect doing the job awesome , for almost 3 years and still . Great product

Ya la instale en una Silverado 3500, 2006 y hasta ahora funciona bien, incluye su instructivo, el gato hidráulico es de 5 secciones para un máximo de 22 toneladas, la bomba no se forza al momento de levantar, hace su trabajo sin problema. Recomendado.

Very fast delivery and works great. Instructions could be better. Doesn't explain how to hook up the 12 volt battery.