KUAFU Strut Tower Brace Compatible with 2008-2023 Dodge Challenger Front Twin Tube Design Red Steel Powder Coated

Bought for my 2013 Dodge Charger. It doesn’t line straight up however if you set it on top of the bolts where it’s barely on the closer two, you can use a small pry bar on the other side and move the strut bar into place where the bolts line up on the holes. Very good quality build and for the price, probably best bang for your buck if you’ve got a Dodge Charger

This is a well-made product, at first I thought it didn’t fit, but turned it around and it fit perfect. My only complaint is the red was not as bright as I wanted, but I just went and bought paint and repainted it myself for under $10. Looks great and you can’t beat the price. The third pic you can see colors was off for what I was looking for, so top pic is the repaint which came out great.

Its a tight fit. I installed a tower strut bar in my other vehicle and it was nowhere near as much as a fight as this was. Granted that was three parts compared to this being one solid bar.I had to start the nuts on one side and pry the opposite to finally get it on. This was after nearly putting it on backwards. The Im not sure if i should blame the product or the fact that I got the car after it was lowered by the previous owner (incorrect installation?)Aside from that the overall quality seems solid. The red isn’t bad would like to see other color options then again I can always change the color myself.

Simple to install and looks great! Heavy made with quality materials.

The title says it fits a challenger and I took the risk to see if it will fit a charger. Mine is a 2020 dodger charger scat pack. It took some convincing and it touches your a/c line but it can be litely be bent away a little. Then you’ll have to start nuts on one side and the use a pry bar to get the other side to sit down. After that it’s just torquing all 6 nuts down! So long story short it will fit a charger!!!!! I give it 5 stars because it is a sturdy built brace and it says it is for challengers and I made it fit a charger

This upper tower bar is an amazing product, very sturdy and easy to install. I definitely felt the difference since last time I used launch control I felt the car flex a bit too much and caused the car to feel loose, I installed this awesome bar and my first launch with it on was straight and true. These 6.4L hemi’s are practically super tuned out the gate so any mod that can be added to make it more well rounded is welcomed. I also bought the hellcat cold air intake box from this company and it was also awesome.

Doesn't fit. I've tried 2 and returned the first one. There is always 1 hole that is 1/4-1/2" off. 1 volt is on the edge of the hole but could probably be forced on if not for the one so far off. No amount of prying or adjusting can make it fit. The first one I received was the same way. Both were just tossed in a box and had punched through the ends of the box leading to scratched ends and damaged paint. Save your time and buy a decent one.

Looks great on the car. Fit like a glove. No issues at all.