Pattern Flush Trim Bit 4 Pcs Router Bits，Top Bearing Flush Trim Bits Set，1/4 Inch Shank ,Cutting Length 1/2", 3/4", 1", 1-1/2"

Good deal! Price is spot on.

Excelente

Muy útiles

Stay sharp for quite a while definitely worth the money for the selection

I used them to trim 3/4" mdf when making a template for my new router lift. I used a 3.5HP Makita and a 1.25HP Bosch palm router. The bits cut smoothly and cleanly at high rpm and show no signs of burning. I know that MDF is hard on router bits but if each of these bits can work reliably on at least 50ft of MDF edge, I'll be happy to replace them at that point and consider it just an expendable cost.

I ran these hard making some unique butcherblock floating shelves. These worked well and treated me nicely.Make sure you tighten the set screws for the stoppers and everything should be good. Do not trust the factory tightness, I had two slip on me but it was alright in the end.

These are well made (China) and work well so far. Extra bearings and a wrench are included.This was purchased to cut pvc with a 30k rpm Rotozip using a template. The bit did a clean with the ball bearing against the template.

A nice set of bits. ready for my next project