3D Printer Parts 36mm Motor Extruder Stepper Motor 1.8 Angle 0.35A 2 Phase Round Body with 47.2in Cable for Sherpa Mini/Orbite Extruder Ender 3 Pro V2 /Voro 2.4/Positro Project Accessories

This worked great for me on my Stealthburner with CW2, lots of torque. When I first installed it the stepper was getting quite hot but I realized that the pancake stepper I had previously used was running at 450 mA, as the directions stated I ran this down to 280 mA to start and it ran perfectly at that driver current so I have not increased it. Currently going strong and working on a full plate of VZBot parts without skipping a beat. Read the included paperwork and set this up correctly and it works great!

Motor has been working well. Thought I had a problem with it but it turned out to be the wiring.

I have 2 of these in service currently, 1 in a Voron 0.1 mini afterburner and one in a Ratrig V-minion sherpa mini setup, both are performing flawlessly. I have cranked the current way up to about 600ma but as one of the other reviews indicates, it’s still ice cold.

No issues so far. Swapped my extruder from a more standard NEMA 17 stepper to this and just had to adjust the steps/mm to account for an added gear. Also had to lower the current since this runs at a fraction of the full-size stepper current.

Installed in a new Stealthburner for the Voron 2.4 and have no issues, running v-ref at .65 and motor is not getting hot.