Description
- Material of Body: Brass, Sealing Material:VITON(High temperature resistance up to 150°C or 302°F), Coil: Pure copper coil(More heat resistant, slow heating),Coil Temperature Rising: Below 75 °C or 167 °F.The body is thicker than others,more durable,heavier than others(Ours:1.76 pounds).
- Thread Type:NPT(National Pipe Thread).Woking Medium: Water, Natural gas, Industrial gas, LPG, Steam, Gasoline, Fuel, Kerosene, Propane, Methane, Methane, Methane, Nitrogen, Acetylene, Ethanol, Carbon dioxide, Sea water,Acetic acid etc.
- Operation: Direct Acting. Acting Type: Normally Closed(The valve is closed when there is no power,it is opened when power is supplied to the solenoid). Standard Voltage: AC 110V, voltage range: +10% or -10%,100V - 120V. Working times: More than 150,000 times. Port Size:1/2 Inch. Orifice Size:0.62 Inch. Operation Fluid Viscosity: < 20 CST. Operating Pressure: 0 PSI - 145 PSI(0 MPa - 1.0MPa).Operating Temperature: -10 - 150°C or 14 - 302°F.
- NOTE:NOT use for under water.There are two wires,it will work with either white or yellow wire as ground. Solenoid valve should be installed horizontally, the coil should be vertical upward.Under normal operation there will be mild warming with the coil.Please do not worry, it's normal.
- 100% Satisfaction Guarantee：1 YEAR WARRANTY.If you are not satisfied with our product, no matter what the reason is, we will give you a full refund or resend you a new replacement.With that no risk guarantee simply add one to your cart now.
Model:2W-160-15-AC110V Product Size:4 x 3.2x2.2 Inch Package Size:4.75 x 3.3x2.2 Inch Net Weight:1.76 Pounds Package Included: ONE Electric Solenoid Valve NOTED: 1,The pipe must be cleaned before installation . 2,Please check the pressure, temperature and voltage before installation to ensure that these data are consistent with the solenoid valve parameters. 3,Please keep the medium clean, regularly check the gasket, if you find the gasket damaged should be replaced immediately. 4,Installation steps: first use a wrench to fix the valve body, and then screwed on the tube.Please do not put the force on the coil, to avoid the internal deformation of the solenoid valve and the loosening of the connection leading to leakage.Please make sure the direction of the arrow sign marked on the valve is the same as the following direction of the fluid through the pipe. 5,After installation, the fluid must be operated several times to ensure that the solenoid valve does not have any problems before they can be put into normal use. 6,Connect the pressure gauge on both ends of the pipe to observe the pressure of the pipeline. 7,Inlet pressure must be greater than the outlet pressure, otherwise the solenoid valve will remain open state. 8.Coil assembly shall not be disassembled. Our Product: Each product comes with our brand logo"Old Oak",any unauthorized sellers are illegal, and their products are fake.
