XFLY-MODEL 64mm 12 Blades EDF Ducted Fan with 4S 2840-KV3200 Brushless Outrunner Motor Model Jet Aircraft

All xfly fans work very well with the stated cell counts. Installed into the FMS 64mm Rafale. Plenty of power and sounds good in the air.

Amazing fan, very reliable, powerful and I used these in my hovercraft. They can blow plenty of air while not drawing too much current

This EDF is a very good 64mm EDF and an excellent value.

Over 600 watts with a 4s 1500mah pack. My freewing 64mm f86 always had barely enough power for a hand launch with the included 5 blade fan on 3s. Now I calculate it to have approximately 400 watts/lb of thrust so performance should be insane. Can’t wait to try it out!

I bought this unit to replace a 64 mm FMS unit on my F 16. The stock unit gave the plane a close to 1:1 thrust to weight ratio at around 800 g thrust to give or take 800 g weight. The thrust output of this new unit is a significant increase. It can be felt, pulling harder even in the hand before a throw a lunch, and while the model was not lacking in vertical performance originally it’s vertical performance has increased significantly, I can maintain speed in a vertical climb with half throttle or slightly more and gain speed with a full throttle vertical . Xfly EDF units will be my first choice from now on!

These EDF's sound great!! The Xfly 64mm 4s EDF unit is a fine example. They're well made and efficient. They come balanced with a aluminum spinner and are ready to install. I will buy again and recommend.

Some of these fan units are very expensive and I didn’t wanna throw out a lot of money on one just to fix a foam jet. I subbed this one in and it flew pretty well. Not a tremendous amount of power, but it’s flying. Requires nearly full throttle the whole time. If you’re not looking for stellar performance, and you crash a lot, I’d say this is worth it. I used it with a 4 cell Lipo and a 40 amp speed controller.

Excellent, replaced the one in my futura 64 mm

Alles super