HiLetgo NEO-7M GPS Satellite Positioning Module for Arduino STM32 C51 Replace NEO-6M 3.3V/5V Power Supply

I had tried for hours and hours i just received the initial data but it not fixed and couldn't find the satellites. the light is always green. any help from who worked with them?!!

Para conectarse tarda como mínimo 1 hra

Il dispositivo funziona, ma solo se collegato ad una antenna esterna. Per cui procuratevi l'antenna (pochi euro anche qui) e mettete in conto di dover saldare il connettore SMA sulla scheda. C'è anche l'antenna ceramica montata direttamente sulla scheda, ma secondo me si sono dimenticati di collegarla: con quella da sola non otterrete mai il fix. Sarebbe da tre stelle per quanto detto sopra, ma ne aggiungo una per il convertitore USB onboard che rende superfluo il convertitore UART-USB indispensabile in molte altre schede.

Worked Great. Yes you need to solder the SMA connector on it, and yes, you need an active GPS antenna. I Installed a different SMA connector than the one that was supplied (instead of angle one), installed the ublox driver (GNSS Sensor Device Driver), configured windows 10 to enable gps, and then started windows maps. GPS location worked right off. You can also use a Putty, or something that you can open a terminal serial window on the com port and see the raw GPS data. Everything worked as expected. To test with windows 10, look for the driver and how to configure, google "Connect a GPS/GNSS Receiver for Windows Maps " and this is the info I used. Thank you!

Great price for the module and it works well and is recognized in U-blox U-center. What should be mentioned though, in order to use the sma connector (external antenna) you need to remove capacitor C2. Otherwise both antennas are connected creating an impedance mismatch (bad reception).

Poor sensibility