Water-Resistance IP65, 12V Waterproof Flexible LED Strip Light, 16.4ft/5m Cuttable LED Light Strips, 300 Units 3528 LEDs Lighting String, LED Tape(Warm White), Power Adapter not Included

Awesome product for the quality and price

Light string is very bright. Easy to install. I replaced some older LEDs in a cake showcase.

Pretty good quality I ordered orange it’s more yellow than orange the adhesive isn’t good so order some double sided tape

I purchased these to install under a homemade cabinet. These have only been used indoors so I cannot speak to their IP rating or their UV resistance as others have noted there may be concerns in those areas. For my application, they work perfectly. They were easy to install and soldering wire connections to a switch and 9V battery was simple. The adhesive was a bit lacking when applied to the pine cabinet surface, but I did not intend to use the adhesive alone and used mounting staples to keep them in place. If you are relying on the adhesive alone to hold these you may run into some frustration unless you have a smooth surface and install them on long straight runs. For my application this was not an issue, since I was using mechanical fasteners. Brightness running off a 9V battery was exactly what I was looking for - not bright enough to add accent in full sunlight or a brightly lit room, but for little to no ambient light (which is what my application is) they are perfect.

Do NOT recommend! The adhesive is useless. Clearly the same adhesive for standard strip lights was used, not accounting for the added weight of the waterproof feature. After I installed them, half of the lights did not work (they all lit when I tested them out of the package), and I did not pinch or bend any of the strip. They were falling off in less than 24 hours. VERY disappointed and frustrated. Already ordered something else. These are junk.

Perfectos ( viene sin el cargador) leer Bien las instrucciones

Works fine. But mislabeled as warm white. Very much cold white

I added accent lighting in my motor home, above the wood trim on my main slide. The strip was very simple to install and the adhesive seems to be adequate as it is staying in place very well, so far. I tied into an existing 12v source/switch and am very pleased with the warm but not stark light it emits. See photos of before and after. Since the power source/switch was in the middle of the wall, I cut the strip in half, cut off the molded connector, stripped the ends off the wires, connected the red to red and black to black to the wires coming from the strip on the opposite end, then ran a jumper down to the switch and joined up to a ground wire. Very satisfied with product quality, brightness level, and adhesion.