Wide Blue Painters Tape, 12 inch x 60 Yards, 3D Printing Tape, Easy Clean Removal up to 21 Days, Masking Tape

I can get over 250 prints with us if not more. if it doesn’t rip when I pull the print off. I simply flip the plate over with the tape on it while the printer heats up and it flattens it right back out and stick it to the plate so maybe even 400 prints. sometimes when I’m printing smaller parts if it does rip the tape, I can do the same thing and just pick a different spot on the plate and it doesn’t mess up all the tape just that one small section. It’s a little difficult to get all the tape off the role is with my feet and unroll a couple inches at a time lay it sticky side up and put my plate right on top of it, cut it with a razor. I don’t roll it over the sides of the plate. I just leave it as is.

I thought I might have trouble ripping pieces straight down but it's actually super easy. I'm using these to stick to the back of wood pieces that I'm adding resin to and the tape pulls off the wood pretty easily but leaves a sticky residue on the resin sometimes. I wonder if it's because I'm adding heat to cause the resin to cure faster. Otherwise, the tape works great, is easy to tear to the size I want, and pulls off the wood with no problems.

This tape is just the right size to completely cover the bed of my Silhouette Alta + machine and much more cost effective than buying Silhouette brand adhesion circles, which cost at least $1 each. I have no problem with the PLA filament adhering to the tape. Tip: Dab alcohol on the tape to loosen it from the completed project. I use my fingernail to scrape the tape from the print -- it comes off easily. I will buy more of this tape when the time comes.

The Good: 12" width fits perfect on my 3D printer bed without having to cut to fit.The Bad: The adhesive is kind of weak, it starts to peel up on it's own within ~30mins of just sitting. Not sure the brand of my 9" roll I tried to replace with this roll, but but the old 9" roll does not peel up on it's own.Would have given 5 stars if the adhesive was a bit stronger.

It’s a little hard to work with bc it’s so wide but that’s me and not the product. Otherwise this was very effective painters tape.

*Very* sticky. *too* sticky. Can't get a piece more than about 3 by 4 inches off the roll before the tape tears. Impossible to get a piece the whole width off. Do not order. Whatever you do manage to get off the roll will stick too hard, and may cause damage to underlying surfaces. Tried this as a mask for laser cutter, total fail.

I saw the reviews and was nervous about buying this. I have now used over half the roll on projects with my laser engraver and even if the edge pick up a little bit dust or crap from the work area it still has worked amazing. It peels extremely smoothly and if you fold over the edge when done starting the next piece is super simple. I have used it on everything from Glass, wood, aluminum, to acrylic. I will being buying it again and would HIGHLY RECOMMEND anyone else to buy it also.

It's not permanent tape. It is made to peal off and it does. I found it very easy to work with. It stuck when it needed to stick and it came off when I wanted it off. This extra wide roll is what you would normally use for painting, but I was doing an unusual job and it came in handy.