Birch Wood Veneer Edgebanding Preglued 3/4" X 250' Roll

This edge banding was very easy to apply with heat from a common household iron. It was easy to cut and after it cooled, it adhered well. I believe this performed quite well and was a great price.

Excellent product, goes on nice and stcks great. Makes edging of plywood look like real wood.

I used this edging on shelves. It applied easily and securely using a household iron (with the steam turned off). I applied the iron and followed up by pressing hard with a metal cement trowel to compress the bond and cool the glue at the same time.

This is good quality edge banding. Pay close attention to the width measurement of the edge banding VS the width needed for your project. This edge banding is not ideal for 3/4” projects. If your an expert, you may be able to pull a 3/4” project off, but there is absolutely zero hang off (see photo). My project is 1/2” MDF I will be veneering in lays to for use as samples. This edge banding works perfect and the corners glue up seamlessly.Some reviews complain the glued together pieces are obvious or spaced too close together, making the edge banding difficult to work with, or unusable.1.) All edge banding this length will have many glued together pieces. There will never be a 250 foot tree cut and milled specifically to create edge banding.2.) Where this edge banding is glued together, it is a very wide zig zag, about 1” (see photo), and not obvious until you put the banding to your face and search for it. In the photo you can see the glue up on the raw edge banding. I had to get in some good lighting and tilt the banding at an angle to make the glue up obvious. After the edge banding has been glued & lightly sanded with a flat block (emphasis on LIGHTLY), using 400, 600, or 800 grit sand paper, its impossible to spot (see photo with my finger pointing to a glue spot that cannot be seen). The only issue you may have with the glue section being problematic is if you do not use something between your iron and the edge banding. If you apply banding with a lot of pressure, as with all banding, some glue may rise up to the surface. This can make the surface just sticky enough to catch film or dirt off of the iron...the dirt On the iron is the problem, not the edge banding. Recommend using wax paper between iron and banding for glue ups. When the wax paper has been used several times, replace it with a fresh piece.3.) I measured multiple areas to find the length between glue ups. My roll had glue ups, each one exactly as shown in the photo, around every 4 feet, pretty standard for this size roll.All in all, this is good quality edge banding at an exceptional value. The price of this edge banding will buy you 25’-50’ at the big box stores.RECOMMENDED

The colour is very nice and consistent, as is the grain. The glue is very evenly applied and is a dream to use with a hot iron. My only downside is the packaging was just a plastic bag with no protection, resulting in the first 2m (6 ft) or so being unusable. As shown in my last photo, the veneer takes a variety of stains, waxes and finishes really well. I am exceptionally happy with the quality of this product.