MEASUREMAN Tridicator, Thermo-Manometer, 2-1/2", Silicone Oil Filled, 0-160psi/30-250 deg F, Stainless Steel Case, 1/4" NPT Lower Mount Pressure Gauge

Worked perfectly with my heating system boiler.

I need to keep an eye on the temperature of epoxy resin as it cures in the pressure pot. This gauge makes it easy to check both psi and temp, and the large gauge makes it easy to read.

Great product and really enjoy the colours. I used them for a project and didn't really need the accuracy. I bought two and hooked on the same water line that runs about 60psi. They read 10psi different, but at the price these are sold, they are not calibration prices. Thank you for providing them. I love the temperature on them too. Without the long sending bulb they take about 5 seconds to read, but exceeded my expectations for the project I needed them for.

It's a gauge. Simple. Pressure needle is good. Temp needle won't go above 100⁰ for some reason.

pressure readings are taken right at the pump house where the water goes to the garden. the temp is important as i can compare the temp leaving and the temp at the drip emitters and get an idea of the btu absorbtion along the route.this has helped me to modify some water schedules.

Very nice gauge. works great on my 4L60E transmission

Used this on my Wilkerson regulator and so far very happy. I was not thrilled with the amount of Glycerin used to fill it. There was a large bubble in the top making it hard to see the pressure. I filled it with vegetable glycerin and it seems to be different than what it is filled with from the factory causing it to separate. However I like the dual use of it with the temperature and pressure.

Using to measure reverse osmosis pressure and temperature for aquarium use.