Iverntech 42 Nema 17 Stepper Motor 60mm Body 1.8 Stepper Angle 1.5A 2 Phase 4-Lead with 1M Cable for 3D Printer, CNC Machine and Robotics

Installed as a light weight direct drive extruder motor and is working well. Nice that it comes with a 1 meter cable too.

Used this to replace the Y Axis Motor on my CR10 - S5. It fitted perfectly but does need the centre pins swapped as the seller states. I reused the Creality cable and if you are careful you can remove and reinsert the pins by lifting the white retraining clips with a small screwdriver. It has been running for a couple of hours now and is perfect.

Used this for a disco ball strong motor good control using a 3rd party circuit board.

Like the fact it has flat sides so the grub screws grip but don’t like the fact I had to change the pins around on the motor end of the wire to make it work correctly

Seems like a decent motor except for the hassle of having to rewire as it does not use the same wiring config. of my Ender printer. The centre two wires need to be swapped.

These motors are not compatible with ender printers, unless you swap wires over. This isn't a simple thing to do, and the extension cable has no facility for you to do this without the risk of breaking something.

Used to replace a faulty Motor on My DIY CNC router. Great quality and you can clearly hear the difference from the original…..