Pair of 1" Dual Black Motorcycle Bar End Hand Grips Handlebar Compatible with Cruisers Harley Yamaha Suzuki

The media could not be loaded.  Fit is pretty good. Had to wrap the bars a couple times with electric tape for a perfect fit. After about six months of ridding with them the fake chrome is starting to pit & the rubber is wearing pretty quick. But for the price compared to the real ones, great deal.

The grips were good and felt comfortable. I wrapped some tape around the left handlebar and ran a couple of lines of silicone then pushed/twisted the grip on and it is rock solid. I pulled the plastic inner sleeve out of the throttle grip and installed it by itself. Same bit with the silicone, push, and twist to get the grip on and aligned how I wanted it. I took the wrist rest off and let the grips cure overnight.There was some casting flash on the holes of the wrist rest which were keeping it from rotating for adjustment like it should. A minute or two with a round needle file cleaned it up and it installed and adjusted fine.All of the chrome parts are metal and feel good and the rubber is comfortable and looks great on the bike.

I put these on my 2006 Harley Dyna and I love them. I should have had them years ago. The installation was not that difficult at all. However, I only gave 4 stars for that detail due to the glue that comes with the grips. The supplied glue sets up VERY VERY fast. As such, should you encounter the slightest of difficulties and thereby delay in sliding on the grip, the grip will be virtually impossible to fully slide on and into proper place. You better get things right quickly and immediately. I did in fact encounter some difficulties in that regard, but nothing too major. If I had to install these again, I would go to the hardware store and find a more suitable glue that offers a bit more drying and setup time.

Adhesive that holds it together is horrible...had to re-do.

They look good but take extra steps to install slightly oversized for sure I used gorilla glue spray and electrical tape to get them to fit and they seem to be sticking now. Also finish under the paint is kind of rough but not terrible just able to see a few rough spots from casting it looks like

I bought these for the look, and I can’t complain! They don’t come with glue, so make sure you have some super glue on-hand for the install. Overall install took about 20 minutes. I think I will have to take the throttle grip apart and glue it because I’ve noticed it slowly rotating, but it doesn’t cause an issue with the throttle itself. Perfect fit for my 2009 v-star 1100!

The throttle works great, but as others have said you need to get a good glue for the left side because it will slide right off. I used e6000. Others have said use electrical tape then glue. I would t recommended that. Just use a good thick glue

Works great. You will need glue to keep these on the bar. I used locktite spray glue adhesive and it worked amazing. Used on one inch bars for my kawasaki Vulcan 1600. If you glue it and still have issues tske it off wrap some electrical tape where the grip will sit and then try again. Worked wonders for me

J'adore très beau et confortable 😊

Very comfortable, Needed to have them professionally installed as you have to loosen throttle cable. was quite hard of an installation

Easy install and very comfortable.

Happy with my grips. Will continue doing business

Great fit, very sturdy.