🔗 Connect & Control: Elevate Your Remote Experience!
The IR Infrared Emitter Extension Cable is a 1.5-meter long solution designed for seamless integration with IR remote control devices. Featuring a 45-degree emission angle and a 3.5mm jack, this cable ensures low power consumption and versatile applications in audio/video transmission and centralized control systems.
M**S
Works quite well
I do a lot of automated IR control work and this is a very cost effective item. Even though it's not the highest of quality as I've had a few issues with the plastic cover falling off after dropping it, (my fault) it's priced right and I will be buying more of these. I am very pleased with this purchase.
J**R
Works well
Good length. Easy to install.
K**R
Works well with my older Denon and Yamaha receivers
Emitters seem to work well positioned a centimeter or so above, below, or beside the equipment IR receiver. I have one IR receiver in bright sun for parts of the day, and the emitter works fine in those conditions. I plugged these emitters into a DIY circuit attached to a Raspberry Pi 4 and control them with ir-ctl.While I appreciate the seller answering my question regarding a diode datasheet, I believe they are mistaken. These emitters absolutely include a diode (the 'D' in IR LED). Without a datasheet, I took a shot and used a 120 ohm current-limiting resistor with a 5V signal. Working well so far.Regarding adhesion, I wiped the emitter base and the mating surface with isopropyl alcohol before applying the adhesive pad. Seems good so far, will update if it fails. **UPDATE: the included adhesive pads are no good, fail within days. I'm using 3M's Scotch Mount Indoor Double Sided Mounting Tape instead.
J**N
Good value
The adhesive tape seems a little foamy, so the emitter pulls away from the surface it’s mounted to slightly, which is purely a cosmetic gripe. These don’t have an led indicating to the eye that they’re transmitting but they’ve worked great with my control4 controller
T**K
Electronics
Functions as expected
F**Y
Completely useless..don’t work
The only way to test a non blinking IR Emitter is with a phone camera. An IPhone camera is sensitive enough to pick up the IR flash. I tested a whole box of these and none actually emit an IR Flash from my Connect4 controller. Zero, work. If the camera doesn’t pick up a flash there not working. Avoid these..not recommended.
H**S
Good value replacement cables
I needed a replacement emitter cable for my AV receiver, and the first one I tried out of the pack worked perfectly. I haven't needed to test the other four yet.
J**Y
Not a true RF
These don’t work with all remotes.
Trustpilot
1 week ago
2 days ago
