Universal Motorcycle Tail Light

The media could not be loaded. I had to order a second one after The first one i ordered lasted about 4 months of light use, then it just stopped working. No biggie since it was only $12, the pain was just re-wiring it. When i ordered a second one, and when installing I found out why the first one stopped working, the red wire just fell out of it when removing it from the bike. Poor connections to the circuit board and nothing securing it the wires from getting yanked out, so on this second unit I reinforced it with a bunch of hot glue, both on the back of the light, the protective wrap, and also the connections. Should hold much longer now but beware, the wires come off the circuit board easily so I would recommend gluing the wires securely to the rubber grommet so they dont pull out of it.Otherwise its great for such a cheap price, nice and bright lights, the turn signals DO NOT BLINK unless you add a flasher relay like I did or if your bike already has them. You can see my flashers working in the video, and I have it mounted upside down so I could use the license plate holes to mount to the rear rack on my Coleman. I run it off of a 4s battery I had left over from some drone stuff which is up to 16v so it can handle a little more than just the 12v its rated for.

I needed a low amp solution for my break light tail light on my Coleman 200 mini bike. I also needed a bracket to install a license plate. The license plate bracket holes were too small/narrow to fit my plates, but a drilled a couple holes and worked well enough for my budget. This works great. I decided not to use the built in blinkers as they are too dim. You wouldn’t be able to see them with the break light on, on a sunny day.Great tail/brake light though!!!

For the most part, the product works really well. It was easy to wire up and the lights work well my only issue is the blinkers don’t blink. It’s just a solid light so other drivers don’t know that I’m actually trying to turn. I will be installing a mini blinker fuse, so it will actually be a real blinker. Other than that I highly recommend this for anyone!

Used on minibike, works really good, bright

I like it so far but it's hard to mount to a honda rebel 250cc

Amazing price, installed on my 2006 Monster S2R 800 in like 20 minutes after I smashed the old one trying to do wheelies. Using two sets of pliers I flattened out the angle of the bracket that holds the license plate cuz the plate was pointed straight at the sky.I’ll come update my review and lower the stars if it gives out in a few months.

Where is the front part that connects to the rear light?

Just installed today, everything works perfect. Nice and bright. Holes for license plate are not correct for our state. Drilled new ones. Instructions on picture on Amazon.