Xitomer Fender Eliminator Fit for ZX650 Ninja 650/ Z650 2017-2025 & Ninja650 ABS 17-24 & Ninja 650 KRT ABS 22-24 Tail Tidy License Plate Holder(Black)

Perfect fitment. No complaints. A+

Fitment was spot on and gives the bike a cleaner look. Definitely worth the money to eliminate the factory bulky setup. Keeping the factory turn signals looks good too..

Installed on my 2019 Kawasaki Z650. Easy to follow instructions. The bolts that came with it to replace were tough to get in the holes closest to the lights but honestly, they were not needed if you use loctite on the other two and wrench them down with an impact.

Looks great, easy install. A must to clear room for a lift. A must for your sport bike.

Fits 2020 ninja 650 with OEM blinkers perfectly. Only complaint is the 4 screws that go into the bike are very long so it takes away from the already small space underneath the seat, but I will be buying shorter screws eventually.

My fender eliminator broke and the seller offered me a new one as well as a refund

All I received was the main mounting piece shown. I read the description to see if it did include the mounting bolts and it in fact does say it is supposed to come with them but it did not. The piece itself seems sturdy but I didn’t get anything to mount it with. But, after customer service had noticed their mistake they were quick to correct the act and make everything right.

It looks pretty good. Taking apart the old fender was a pain. For the price compared to the better ones this is a no brainer

The shipping came quick was a little hard to install if ya have stock lights still but does tidy everything up and looks amazing

Product fit OEM turn signals, plate light perfectly. No complaints other than shipping time, although not seller's fault. Very clean installation.

I got this for my Z650. The holes are not in the right place . Two of them are so close to the corner that you can’t pass the bolt through them so I had to use the original bolts which are very short and undo the tail light bolt to pass the original bolts. And because they were short it was very difficult to tight the nuts. I almost gave up and wanted to return it but finally able to figure it out ant put it in place. At the end it looks fine but the installation was quit changing and annoying. So I’m not sure if I would recommend it. Now I know why there are eliminators in the market for over $150 to $200.