Universal Fence Clamps for Woodworking – Secure Auxiliary Fence Setup Woodworking Clamps Set To Prevent Damage - Easy-to-Grip Heavy Duty C Clamp for Table Saw Accessories & Carpentry Tools

As with most products I've purchased in the past from Rockler, the Universal Fence Clamps work exactly as advertised. Easily adjustable and quick to install. All that's necessary to attach your auxiliary fence is that you drill a 3/8 inch hole into the top edge of the auxiliary/sacrificial fence for each clamp that you are using (typically you'll need both of the clamps included in the kit to attach your auxiliary/sacrificial fence). I think it's the great table saw accessory for the DIY'er.

My saw fence on the new Delta 36-5000 saw is difficult to attach a sacrificial or auxiliary fence to; these clamps solve the problem. If I need a high auxiliary fence, it is a simple matter to glue or screw a higher fence to the one held in place by these clamps.While I can't compare them to other, similar clamps,I can say that the quality is excellent and the clamps fully meet my expectations

These can be use in different ways besides holding a wooden fence to the metal rip fence on table saws for use with dado blades or cutting kerfs right next to the saw blade without damaging the blade or metal rip fence. They can also be used for hold down clamps on the edge of a work bench.

Works well. I put holes all the way through my sacrificial fence so I can flip it over. Only negative is that the clamps don’t have rubber feet covers, but I may put a piece on them.

The clamps hold my auxiliary fence tight against the existing fence. I was concerned that the bottom part of the auxiliary fence would not stay flush with the existing fence, but this has not been the case. Clamps keep it tight and square.

I like these. They are small yet very effective.

Wish I had bought this years ago. Easy to use and very sturdy. Make sure you use a good quality plywood for your best results.

I used these to make a sacrificial fence on my table saw. They're a bit limited in their capacity (jaw size) but work great on my setup. Glad I used these over a more expensive option.

Have been looking for these clamps for years! Just what I needed

Very good product

Clamps sacrificial fence to table saw fence without the obstructions of larger clamps.

Very practical ,has multitude of use,good product

These Rockler brand clamps are OK, but when paying for this brand name, it would have been better if they were a little more robust. There may be larger sizes, I am not sure, but these ones seem to be on the small side. They did the job and worked for the sacrificial fence like they were supposed to. However, when I tightened them down, they start to distort and bend. This goes back to not being robust enough. If you are only using them occasionally, they are fine, but if you are doing production work, I would suggest you get some clamps that are more heavy duty.