30Pcs 5MM 12V White LED Pre Wired Lamp Light Bulb Prewired Emitting Diode & 30Pcs Metal 5mm LED Clip Holder Panel Mount & 10Pcs 9V Battery Holder Clip Snap On Connector Cable

I bought these guides for a Halloween themed STEM activity for my 4 year old. The colors were bright and look great. Very easy to use. Easy to make a super simple circuit with these! Great price and you get so many!

good item

A little delicate, very bright, should use ~800ohm resistor to limit current

Awesome value for your money. You got a lot of different LEDs and a lot of different colors. Had zero issues with functionality. Very happy with this. Colored diffuser means you get color and all directions.

This is a nice little kit for the money. I used them for indicating lamps on a large press. They run off 9V batteries no problem. Nice and bright. The only issue is the small plastic piece the holds the LED in metal holder. It is made for the leads on a un-soldered LED. You have to enlarge the holes to make them fit the pre-wired LEDs with shrink wrap on them. I glued the plastic holders in place with super glue and have had no issues whatsoever.

Simple LEDs for a few projects. Nothing exciting, but work well.

All other colors were fine as tested, however all but three of the reds (the color I needed at the moment of ordering, of course) crapped out as soon as they lit up, 3 were nearly half power. Lit up bright but faded withing seconds. I needed 4 for the project at hand. So close.

Got these for a toy I was building and they worked great- very nice to have the leads pre-attached

work great nice and bright

Couldn't figure out why they were burning out in less than a minute until I realised most of them don't have resistors. Worked fine after I installed 47R in positive line. Also noticed that the resistors that were installed on some of the prewired sets are very close to diode which is a significant heat issue in a confined space on a model. This is my first experience with LED lights on model ships and for future builds I will be making my own from scratch with individual diodes and resistors. Not too dissappointed as I have enjoyed the learning curve and happy to confess I knew zero about electronics before this project.

Gutes Licht, leider sind die Pinken Lampen nicht anzuschließen. Nur deshalb ein Stern weniger.

Second purchase, love these lights super bright and easy to install. Used in a display

Fiddly To Use:The small opaque LED clips/holders secure the LED to the chrome holder nicely but the two holes, for threading the wires through, have to be enlarged due to the shrink wrap around the wire at the connection points (between wire and LED connector). Fiddly but fairly easily accomplished.Partial Kit:It's a shame the kit doesn't come with a matching number of mounts and plastic LED clips/holders (only 15 supplied) or any install/use instructions. The quantities were as advertised but surely 30 mounts and holders/clips could have been supplied without affecting the cost?!Overall (4 of 5 stars):A good quality starter kit, delivered on-time. However, recommend you research thoroughly and buy separate kits of LEDs and mounts for better value and a complete matching set of components.