TACwolf 2 Pack Tactical 1" Offset Mount for Flashlights

These mounts have a little better quality control than other copies I've bought on amazon. They are so cheap you really can't go wrong. I measured the interior diameter with a caliper and it came in at 0.960 inches, which is close enough for me. I used the UltraFire Mini flashlights in these mounts, which are a little small so i made up the difference with electrical tape and it worked out really well. I've used larger lights in the past but I just can't deal with a massive/bulky profile they create on the end of the barrel. The beam for the UltraFire lights is a little narrow but you cannot beat the combined weight of the light and mount, it comes in at about 4.5 ounces. These mounts hold up well to recoil, as long as all the screws are loctited down. The only modification I made was that I replaced the thumb bolt with a wingnut, making it easier to tighten down and take off. Also I added two washers: a standard and a lock washer to make sure it doesn't come loose.

Bought this for my shotgun, but will use it on my AR also. Takes less than 30 seconds to switch out. The fit and finish are really nice, and the thumb wheel is a plus. This is the same quality as some other more expensive mounts I've looked at. It's inexpensive, but good qulaity.

Watch the tightness of the screws often if you have a lot of recoil!!!!

They are high quality 1" flashlight offset Picatinny rail mount. The black finish is just right and not too shiny. The machine work is smooth and clean and it mounted nice and snug to my rail. One for myself, the other for my wife.

These are too small to fit a 1-inch flashlight unless you're prepared to beat the crap out of said flashlight to force it into the two halves of the ring that surround it. They are low in price though and work as long as you don't mind damaging your flashlight to force it into the mount. It also would be nice if there was the option to use a screwdriver to tighten the mount onto your rail, but you can only thumb-tighten it. Nice if you're expecting to have to remove it without tools, but not so nice if you'd like a more permanent attachment. I shouldn't expect much for the price, but I did at least expect it to fit the size of flashlight that it's supposed to.

Great value. It's a a little tight on my Anker 900 lumen but the body of the light is 1/32th wider than 1" so I believe a 1" light would be a perfect fit. It's still a good fit on my Anker. Highly recommended

Not sure why theres a rating for warmth. But yes they're very warm. I use them to hold a little flashlight one of my rifles.

fits a standard rail just fine