100pcs - 10mm Nylon Clips Plastic Push Type Rivet Retainer Fastener Bumper Pin Fender Flare Compatible with Honda Acura

Good Value!

These work good for a OEM replacement. I only needed a few but you have to order 100. I will give them as door prizes at my funeral, cuz I will never need them all.

I used these on my 2005 Honda Element when I needed to replace some of the clips that had broken when removing the plastic panels to change my fog lights. They fit well and worked out perfectly!

My Wife's 22 CRV fender liner was torn off when she had a 'cone intervention'. Easily fixable, but Honda uses two different sized push clips (and a few other connectors) on the 22 CRV fender line. I had the smaller ones but did not have this larger variant. A whole bag of 100 was cheaper than 4 of these from Honda and they appear to be good quality with no issues on the road so far.

you have to put these together yourself. i agree with other sellers; they are a little on the soft side. I counted them once I assembled them together. received only 88/100 pcs. one piece arrived broken.The are probably 1 time use. They are difficult to remove, even with proper push-pin pliers. The head of the push-pin is too thin and flush with the head of the retainer piece. it makes it difficult to wedge the push-pin pliers under the pin if you wish to properly remove them.low quality, but at least you get quantity.

My civic had many clips broken and missing. I got this pack and replaced them myself. Easy and less expensive than the dealer.

I have a 2015 HONDA ACCORD V6 COUPE. 100k mi. I damaged my fender well liner over time.. When I replaced it. The old clips never worked well again. They worked their way loose and I damaged the liner again. The fender liner connects to the underside splash guards and bumper cover. All 3 of these body liners/guards connect to each other and to the frame. They must be done right or the whole system fails.This time I got the 3 different types of fasteners needed and fastened things down right. With these clips and the other 2 types needed, your Honda will be buttoned down tight!This item is the 10 mm clips that go in every hole UNDERNEATH the car. Probably a dozen holes. Fill every one! one missing clip places undo stress on the others and the bottom will sag, rattles bad, and will not hold long term. With 100 you have plenty to fill them all. I even replaced the original brittle clips and these snap in much tighter.For inside the fender well you use a bunch of 8mm push pins (6 - 8 per side?). Finally against the firewall side, you use square push rivets (3 per side).Both available on Amazon:1. 8mm - for inside fender liner - GOOACC Nylon Bumper Fastener Rivet Clip 8mm90682-SEA-003 – Square Push Clips – No Center push post2. Rexka 40pcs Fender Apron Liner Mud Guard Retainer Clip Grommet Retainer 90682-SEA-003Now the car is like new again as far as the front end appearance and fitment. Very satisfying as you see so many cars on the road with flapping liners or underside sag. This is an easy fix with the right parts.

Poor quality but it does the work