5100-5 Aircap Set #5-1.8mm for T-Model Spray Gun

It is really difficult to get solvent/oil based finishes in California and spraying Alkyd enamels has been a problem for me. I purchased this tip for use in a gravity fed Fuji T series spray gun using a mite mate 4 HVLP. I was previously using a 1.3 needle but needed to thin with water and flotrol and help the finish level out but with this aircap set I spray alkyd enamelss traight from the can and get a nice wet and even finish. I am by no means a professional but find this combination works great for an ameteur like me.

Used it for BM Stix primer and BM Advance paint. Worked very well. Make sure to use ford cup to dilute paint with water (yes you can and should dilute even if it says not to).

Perfect addition to my Fuji sprayer system.

Worked perfectly for spraying General Finishes Milk Paint thinned with 10% water with my T70 bottom feed gun and Mini Mite 3 setup. Couldn’t ask for anything more.

If you are spraying cabinet doors with latex then this is the tip you need. I has a 2.5 and a 1.3 and neither were getting the job done. It’s pricy but it made my 700$ sprayer actually work.

If your buying this you must already have a FUJI system. I required this cap set for spraying catalyzed lacquer with my T-75 gravity feed gun mini mite. It was a must have for this heavier product. Fuji is one of the best professional consumer grade guns money can buy (other than Apollo).

I would probably love it if I was better at spraying. I bought this to spray latex specifically Rustolium Painters Touch. I thinned the paint by 20% and it looks amazing. Much better than the #3 tip that came with my gun

Sprayed latex primer and paint through this air cap. Very happy with the results.