100ft(30.5m) 22 AWG 4Pin RGB Wire Extension Cable with Spool, Led Lights Wires Strip Extend Wire for 5050 3528, with 8PCS RGB Led Strip Connectors

other than the trash white connectors that come with it. Its decent wire

The wire is great and easy to work with.The clips work perfectly for attaching together two strips of 10mm LEDs, like if you'd accidentally cut the strip at the wrong point because you don't need to measure it again - you remember where you're supposed to cut it, and if your wife tells you you're cutting in the wrong spot, what does she know? You've got an engineering degree and women are notoriously bad at measurement stuff, so SNIPPITY SNIP! *Sigh.* But hey, these clips work great for fixing the LED strip. In my case, a heartfelt apology, admission of being a brick-headed d-bag, and a pint of Häagen-Dazs fixed the other part.Trying to use the clips ON these wires, however, was a different story - perhaps if I'd tried to solder them in, that might have worked, but since I was soldering I figured I might as well solder them directly to the LED strip. When I tried to use the clips without solder on the wire, the act of closing the clip moved the wires away from where they needed to be in order to work. There may be a trick to using the clips with the wire, and that may be in some instructions somewhere, but I've got an engineering degree so I don't need to read instructions. Or verify measurements.Since I didn't try it myself, I'm theorizing here, but my wife says I'm OK at that... for a brick-headed d-bag. Soldering them to the clip might A. melt the clip if you're not careful, and B. make a connector that you can snap onto an LED strip and then unsnap it at a later date. When snapped on, it's really secure, so if you want to make a really solid but temporary connection to an LED strip, that might be a great way to go.

I purchased this wire when installing my under cabinet lights. Worked great for extending between cabinets and lays flat for concealment.

This is an essential piece of kit for people looking to install multiple lengths of LED strips in series to a single receiver. You will need different adapters than what come with this kit, and they're very flimsy and while the 'bite' just fine to the ends of RGB ribbon, they do not seem to be designed to clamp onto bare wire. Get a pack of adapters that have holes one one end and a ribbon clamp on the other if you want to use cable like this to bridge multiple light strips.

I used so much of it extending the wires for all the lights in my car, and under my car, that I had to buy another roll.I can only guess a lot of the negative reviews about the wire and clips no worming together is going to happen, can't please everyone!I threw the clips out without even looking at them twice, I ordered the wire for the wire and it works GREAT!

made to last

Worked very well for my needs. I found using the connectors was difficult. I had a hard time soldering so close to the other connections without shorting them out. The wire was well made and worth the purchase

It pulls apart well and is easy to work with no complaints here

I should have read all of the reviews before I bought it. The wire is useless with the clips it comes with. So really you are getting a spool of wire And connectors that only connect led to led. This is also my fault for not doing more research. If you are buying this because you think those connectors will connect the wire to the led. It won't

perfect for what i needed