GatorWhite Truck Bedliner Guard Ii Bed Liner Kit

Looks really good, easy to mix and apply, Dries very brittle and just didn't hold up very long at all.

There was a lot of preparation needed and mixing of product before application. The temperature requirement for application is higher than Herculiner. The color match to the white S-10 that it went on to is good. There hasn't been any of the yellowing that was reported in some of the reviews. A good product overall but does require a goodly amount of work.

It is a good product and does what the manufacturer says it will, however It is difficult to accurately determine exactly how much will be needed, because as you know there's always product left in the can that you can't take out and applying with a paint brush isn't easy. I could have used two cans but the cost was a bit much.

Do not buy this product!!! If you can't resist- do not attempt to roll or brush this product, doing so will leave you with a thin white film and lots of hairy chunks. I don't know how you can possibly spray this product as the hairy fibers will certainly clog the gun.The two part epoxy consists of a thick resin (far too thick to pour out of can) and a liquid binder. Mixed well for 10 minutes as directed. I even tried to mix more after the poor results on my test piece. Doesn't matter how much I mixed, still looks like crud. If you have ever tried to paint a wall with a really cheap roller and had the roller come apart on your wall, leaving those stringy messes; well that what this product will do for you expect a thousand times worse. I watched several videos on the Gator Guard black product and they all show the first part epoxy pourig out of the can. I don't know if it is the white product or a bad product but it doesn't pour (much thicker than peanut butter).

Got this to repair the fiberglass on my boat. It works great!

This product was terrible, followed the instructions completely. Product would not dry or setup, instructions said working time was 30 min. Let mixed product sit after it would not dry, never did. Let sit for 2 days and i started to harden to a dry silicone substance. Easily tore when bent, not at all the durable epoxy product it was described to be. Would not roll on at all either, had to brush it on. It looked terrible and looked like cottage cheese, dripped of on the ground. Wiped right off, which was the only good thing about it. Tried to contact Dominion Sure Seal several times by phone and left many messages, no one called back or answered. I ended up using Flex Seal. It worked great, went on great and looks good. Dried to a very durable and hard rubber product.

Just used it seams to mix well and go on easy

It is yellowish white. It is very tough.