QuietWarmth Float QWARM1.5X5F120 Radiant Floor Heating Mat for Below Laminate, Wood, Luxury Vinyl Floating Flooring- Cuttable Mat Size 1.5'x5' 120 Volt (Covers 7.5sf)

Exactly as advertised. Works amazingly. Easy installation and worked fast to keep the floor.

This floor heating system is absolutely perfect. It’s easy to install and works great on a concrete slab floor in our Nebraska home. I found it easiest to lay it out on the concrete slab and mark the routing of the wires and 2 filament contact pads, then I used a Rotozip with a burring bit to grind out grooves for wiring to ensure nothing was pinched under the flooring. I went with the QuietWarmth LV underlayment, WiFi thermostat, and Mohawk luxury vinyl planks (Costco). We couldn’t be happier with how well this product works.

I like this product. I've had just over 1 sq-m installed under a floating cork floor in a small basement bathroom for two years now. The panels cover about 1/3 of the floor, the rest is sink and toilet. The printed panels provide a much more even heat than the wired ones. However, they don't provide *significant* heat. The spec is 12W per sq-ft. So for my roughly 11 sq=ft I can expect about 130W max. That's two incandescent light bulbs worth of heat. Imagine how warm your bathroom will feel if you leave two light bulbs on overnight - not very... The issue is that older floating floors could not take the heat. Now they can. Ideally QuietWarmth will come out with a panel that puts out closer to 25W/sq-ft. Still, our floor is much warmer than it used to be. I used insulating underlayment across the entire floor. With the panels on 24-7 the floor hits 20C. (To those of you in the third world that's about 68 Freedom Degrees). It's nice on bare feet when you step out of the shower. Last thing, I was foolish enough to buy an expensive temperature sensing controller. Don't do it. A simple light switch is all you need. I keep the floor on during the winter and off during the summer.

Absolutely five stars, ten if it were possible. The ambient heat keeps my entire bathroom cozy all winter long if I leave it on a low setting. Was very easy to install, high quality, and so far it's very durable. We installed it last fall and it's been over a year now and I would definitely recommend if this is something you've been considering.

Easy to install, good instructions. The only thing - instructions say to leave a minimum of 6” between mats. I would go lower than that - like 3” instead - I can feel cold strips between them on our LVP floor. It’s less noticeable when the HVAC is warmer, but mildly disappointing. We also used the Sun Touch thermostat (more modern interface). Worked fine even if unofficial.

Worked as it should at a fair price and arrived quickly.

The product appears attractive due to its easy installation and cost-effectiveness. However, after careful examination, it's deemed unsafe for use in living areas. The Electromagnetic field it generates when switched on is equivalent to standing a few inches from a microwave oven. This poses a significant safety hazard, and as such, I will refrain from installing this product in my home.

Self-I stalled on two separate floor installations. Still working five years later.

Perfect for my small galley kitchen.. only required two 10 ft rolls.. side by side.. takes the chill off the floor! Ensure your vinyl flooring is a minimum of 2mm thickness!

In instructions is does not tell you to set wattage on the thermostat and on thermostat it says not required. However at 100 watts it was not really working. When I put the wattage for both mats correctly at 750 it worked wonderfully.

So happy we installed this in our cabin under the laminate. It is so so nice in the winter. Easy to install.

If you are installing laminate flooring this is a great product easy install and works great

Erreur dans les mesures de conversion du descriptif entre pieds et mètres