UPGRADED Lifetime Appliance WB07X10034 End Cap Handle Compatible with General Electric Oven

Items were easy to install

This product met my expectations! It also was delivered in a timely manner!

It's an exact replacement for the GE part at a better price.

Theses are nice looking but they are plastic. They should have included a couple of screws. It would be nice if they have included a few sizes of screws so I did not have to make a trip to the hardware store to install. Nice low projectorey.

Great delivery time. Product was exactly what I ordered.

Old stove new handle exact fit. Reasonable price.

It took a little longer to replace than I thought it would but worked perfectly. I replaced both end caps even though I thought only one was broken. After removing them I found the “good” end was also bad. Replace both at once.

This was an exact fit replacement for the broken handle brackets on our GE range. No modifications were needed and the parts fit together perfectly with the old handle and the door.Installation took a few minutes and only required a T15 Torx bit and a 1/4” socket. I used a cordless driver, but only because it was slightly faster than using hand tools.Ideally the door would be removed from the oven and the handle swap performed on a stable work bench. The door should be taken apart at the bottom and the top. That said, if you like to cheat (like I did) you can simply take the two T15 screws out of the inside top edge, pull the front and back halves apart a little bit and access the 1/4” screws that hold the handle in place through the gap. Just be careful as you could drop those screws into the door cavity! Also be careful that the door halves stay close together by using blocks so that the bottom edge doesn’t get bent out of shape! The inner half will try to slam shut if not held in place!