Ecarzo Mud Flaps for Crosstrek Accessories 2024 All Weather Fender Splash Guards No Drilling Required Mudflap Front & Rear 4pcs Set(Not for Wilderness)

Fit perfectly and look factory. The texture matches the factory trim pieces better than they look in the picture. Received plenty of hardware to install all four. Was able to use the factory hardware to easily install the front guards securely. There was no factory hardware in the rear so used a combination of the plastic trim clip and metal screw instead of the plastic push pin. The plastic push pins that came with the set are soft so the threads are difficult to screw in and the heads are easily damaged.

The package arrived quickly and no issues with shipping, packaging or delivery. The problem is the poor fasteners used to attach it the the 24 Subaru. The drivers side front has already fallen off and lost. Now I have 3 left. The product works well it is just the plastic fasteners.

These were an exact fit for my 2024 Crosstrek. They look original with their texture matching the factory plastic trim . Easy to install and came with enough push pins and screws to complete the job.When removing the original front pins, hold outer rim and use phillips screwdriver to just loosen screw about 1/2 turn then pull out pin and screw. You will reuse these. Don't forget to remove the underside pins too. There are no pins in the rear, only holes. This is where you use the included pins and plastic screws. No need to screw in, just push the pins in the holes then push the plastic screws into the pins. Tighten very slightly with phillips. Don't forget the hole underneath too.

Inexpensive, easy install, and texture matches OEM.No drilling. Remove plastic rivets (3 each), install by putting rivets back.I added some 3M VHB tape to help it stay on.One of the original rivets was a bit short, but I was able to use one of the six that came with the guards.The hardware that came with it is kind of weird.There was a bag 6 plastic rivets. For four guards.There was also a bag of screws, but they were too small for any of the holes.But like I said, if you’re careful removing the existing rivets you can reuse them.Note: some come out by prying the center out half way and then pulling rivet out.Some, which look like a Philips screw, you turn the center 1/4 turn counter clockwise.Be careful turning. It’s easy to strip, and the whole things tries to turn.

Excellent fit,very easy and quick installation

Fits and looks good, but plastic mounting screws are useless. Should all come with metal self tapping screws.

It was claimed to fit Crosstrek and Impreza, but in reality it does not fit at all. Attached is the picture that is supposed to be for Impreza. It does not look like the product that was listed.

The fit is excellent, but fasteners that are included are not sufficient. I had my own fortunately to properly secure the guards.