Imachinist S64121218 Bi-Metal Band Saw Blades 64-1/2" X 1/2" X 18 TPI for Cutting Soft Ferrous Metal Invariable Teeth Pitch

I still use a HF bandsaw around the shop for cutting metal stock. I’ve gone though several blades over the years and and picked up a couple of these as my latest replacements. The seem to work OK. I’ve found they definitely work better when running the saw at its lowest speed. Also, I think these blades are probably too coarse for cutting thin walled stock. They work fine for heavier just 1/8” or more though.These are a pretty good deal. I’m sure there are others that might be better but these are great for the price.

I have used these blades before good quality and a good value

You can spend four times this on a blade, and it might last twice as long. I've accidentally cut a fair bit of hardened steel on this (bedframe) and it didn't dull it any noticeable amount. It seems that in the first few hours a few teeth will break off, or something happens that causes a noticeable rhythm to the blade, but it keeps cutting fine long after that.

I have been doing custom metalwork for about 15 years. When I first started out in 2005, I purchased bandsaw blades from Harbor Freight. It seem like they were always breaking at this place, even though the teeth were still very sharp. I decided to upgrade and purchased blades from Grainger at twice the cost. Pretty much the same thing with the blades breaking at this place after limited use. I decided to go back to Harbor freight and save some money. In my 15 years, I have literally purchased hundreds of bandsaw blades from Harbor freight. The downfall of each one of them was the spice. I figured this was normal.This bandsaw blade is amazing! I have only done about a half an dozen cuts so far, but with the absence of a visible splice, I expect a very long life out of these. Again, I ask the question, where is the splice? I have looked hard and cannot find one.

Excelente artículo, buena relacion calidad precio

I gave a 2 rating on the blade because it broke right where it was weld after cutting just a few mild steel pieces. I gotta give it to the seller though. After contacting them about it, they sent me a new one pretty quick & appologized for it so it's 5 star to them for fast response & shipping. I think it may have just been a grind issue because the blade was thinner in the area where it was welded. The new one i just got is ground very little & i've already cut more with it with no problems at all. For the price, it's an excellent blade, sharp & cuts better than the more expensive blades i've had in the past. I'd recommend it for sure & will be buying more.

Lasts a long time

Haven't had a chance to try the blade yet. Haven't even setup the saw. Too much going on right now. Will come back and rate after I get a chance to try it out.

Well made and seems to cut well.

Exelente lo uso para cortar varios tipos de material

Blades look good and cut straight.

no sirve, no es la medida correcta