ACDelco Advantage 46G0257A Front Passenger Side Suspension Stabilizer Bar Link Kit with Link and Nuts

I bought the left and right and the left seemed to be higher quality. Stiffer movement of the ball/socket and the nuts were better quality. But better than the blown out OEM sway bar links.

My husband and I put this on this past week and it is working beautifully on his 1999 Camry. We have now purchased (but don't have yet) one for the driver's side. At this time my husband has bursitis in his knee so was unable to do a lot of bending of his knee so he used a pry bar to lift up the area that would align the threaded bolt with the hole so that I could get the bolt through it and put the nut on and tighten. The hardest part is the slow pace of using an open end wrench and an allen wrench to get the nut tightened. The allen wrench is needed to keep the bolt from spinning while you tighten the nut. With the small area of room for tools you can only turn about 1/4" turn each time then re-position the wrench again. I found it went faster to turn the allen wrench to get it in to position (until it's tight enough that you can't hand turn it anymore). My husband was so happy to drive his car again without the clunk of the broken stabilizer bar. We do not have to worry about taking sharp corners anymore, either due to this wonderful part. The cost was so much lower than other places, also!

I have a 2004 Avalon and have not been able to find a ready strut for it till now. Thisset works well and fits perfect. The quality seems good so far, time will tell how they hold up. I will make it easy and list all the numbers youneed to get the job done.Gabriel Ready mount strutsG56930G55631G56932G56933You will also wont the strut linkage (if you are lucky you can do without them,but for a little cash - This is insurance from a lot of pain and suffering)AC Delco45G0256A46G0257A46G0328A (you need two for the back)The full set took me about 4 hours in my back yard (I don't have a driveway or alift, but I do have a full set of tools)All the bestChris

This fit fine on my Lexus RX 300. It is Chinese made. AC Delco sells several lines. This part is from the Advantage line is the bottom of rung. Price was reasonable and fitment good.

Works great, installation was easy. Matched the factory part that was broken

Bought this for my 2001 V6 Camry and it fit just like the OEM part. It came with the nuts and bushings for easy replacement. This was so much cheaper on Amazon than at Autozone or O'Reillys, etc.

Seems like a quality product, installed easily. No grease fittings for these. They have the hex key end in case you have to take off for some reason. The old ones were Moogs which didn't so I had to destroy them to get them off.

one thing I notice is the rust forming quickly, on the threads. I live in dessert it has only rained 5 times since I installed both links from ACDelco and i don't drive the car much. only 2400 miles a year. these are cheap.

Used to replace same in 2000 Lexus 300. Easy to install after watching YouTube video

like original no grease fittings, already on my car ,nice and quite .Thank youprice affordable.