Whiteside Router Bits 1408 Round Nose Bit with 1/4-Inch Radius 1/2-Inch Cutting Diameter and 1-1/4-Inch Cutting Length

Well, it looks like you really get what you pay for. I had been routing juice grooves with a cheap core box bit that was part of a starter set. All of my grooves had burning that was a huge pain to sand out. I figured I'd give Whiteside bits a try based on YouTuber recommendations. Just routed my first groove with the new bit, not a single burn mark. I'm never buying cheapo bits again!

Best best on the planet for cutting juice grooves in cutting boards

Clean cuts with my CNC machine. Perfect for cutting board juice grooves.

Seem to work really good and still holding and edge nicely

Did a good job on some cutting boards I made! Very sharp!

Whiteside makes the best bits. Period. No burning in hard maple, even with a 200 lb gorilla on the other end of the router.

This bit performed very well. I ran 30 linear feet of poplar over more than half its' cutting length. I used a moderate to slow feed speed and achieved a fairly smooth finish. There were no burn marks or torn grain. I am very satisfied with my purchase and would buy another Whiteside bit with out hesitation.

Whiteside bits are the best. Precision ground, perfect clean cuts. Excellent products always.