HitLights White LED Strip Lights 4000K 24V, 26.2ft Cuttable Tape Backed 3oz PCB, UL Listed, 1325 Lumen/m, CRI>95, IP20, Lighting for Living Room, Kitchen, Under Cabinets (Power Source Not Included)

Easy to install and connect. Nice and bright,

Using two strips of these side-by-side for a workbench light in my garage. These things are extremely bright and were exactly what I was looking for. They get warm, but not hot. Just make sure you pick a properly rated power supply.One note on the adhesive, they aren't perfect. Since the strips warm up so much, they expand a bit and can "bubble". Might be worth installing them warm, rather than cold.

overall, pretty happy with this product.

The media could not be loaded. To make under cabinet lights with a wireless remote I used the Lutron Caseta dimmer switch with wireless remote https://www.amazon.com/dp/B00JJY0S4G?psc=1&ref=ppx_yo2ov_dt_b_product_details and the 96W HitLights transformer https://www.amazon.com/dp/B09Q7HG121?ref=ppx_yo2ov_dt_b_product_details&th=1 to the LED strip.Simple to wire up using WAGO connectors.I can stick the remote to the wall or the fridge.In the attached photo the strip is at 50% brightness. The actual light is a little warmer / yellower than the photo shows, and you can't see the spots / stripes that you see in the photo.The 26 ft roll was enough to do the above and below lighting.I'm very happy with the results.

The first set I purchased wouldn't work, but amazon was quick to replace them with some that did. These are extremely bright and when paired with a dimmer driver, they look amazing under my basement island and cabinets!

I ordered the suggested power supply and it gets so hot that it shuts off. I guess it cools down a bit and the lights come back on for a bit and then off again. I can barely pick up the power supply. I don’t know if that is defective or if it is the lights but something is seriously wrong with this suggested set up. I contacted the seller and they said that they only recommend using 10’ of the 26’ lights for the suggested power supply. I could not return the lights so I’m out the money. I went to home-depot and bought EXACTLY what I needed for less than half the price!

The media could not be loaded. Been using Hitlights products for years and have had no issues.

Added these to my Omtech AF2028 laser engraver. The lights are super bright. You will not wish they were brighter. The problem came with mounting them.At least on my set, the adhesive on the lights was pretty bad. Did not stick to the metal at all, and I cleaned it well with acetone and then wiped it again with a clean cloth. Tried again cleaning with 99% isopropyl alcohol with the same lousy results. I've done this before on other machines/cars and know how to prep the surface. Guess I just got a set with bad tape. The lights were not usable as they came with the stock adhesive.I've run into this before with other brands, so knew what I needed. Buy this tape: https://www.amazon.com/gp/product/B00PKI7IBG/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1Once you stick your LED lights to this and press them good into the tape, they are permanently bonded. You will need a putty knife to cut/pry them loose. That tape isn't cheap and added to the cost of the lights. Granted, I have more than half the roll of tape left for other things, but still.These lights are not cheap. Good stuff usually costs money and I'm OK with that. You get what you pay for (usually). For what these cost, I expected the tape that comes with them to work well, assuming I prepared the mounting surface correctly, which I did.The lights themselves are super bright. No complaints there. Just be aware you may need to buy mounting tape if yours don't stick at all like my set didn't.