Double Ended Phillips Cross Slot PH2#2 Two Sided Screwdriver Bit Set 10PCS 1/4 Inch Hex Shank 2.56 in/65 mm Length S2 Steel with Magnetic for Power Screwdriver Impact Drill Toolkit Accessory

These are perfect for what I do. I always like to have extra's on hand.

I like the fact that I get double the amount of usage of of these when I always seem to be chipping standard bits.

Price

These bits will not lock into the spring loaded chuck on a standard driver. They will fall out if turn at a down angle.

Holds the screws so far drywall/construction

Locking groove too far from end to work with Snap-On driver. Had to elongate groove to make lock.

I ordered this ‘VESTTIO Double Ended Phillips Cross Slot PH2#2 Two Sided Screwdriver Bit Set’ because who doesn’t need screwdriver bits, right? But I was honestly unaware when I ordered them that they were all the same size….my fault.But at least the size of this ‘VESTTIO Double Ended Phillips Cross Slot PH2#2 Two Sided Screwdriver Bit Set’ is pretty common. And the bits honestly fit any Phillips headed screw I’ve tried them in.What I like best about these bits is how strong the magnetic properties of them are. I mean, they even stick to each other in the pack. A good magnetic bit is important to me, because I am prone at dropping screws when I try to put them in. And the screws do stay put on these bits.I also like this ‘VESTTIO Double Ended Phillips Cross Slot PH2#2 Two Sided Screwdriver Bit Set’ because, for me, the bits are just the right length. They’re long enough not to get lost in my drill and short enough not to be awkward to use.The quality of these bits seem ok. I did have a bit of flaking from one of them when I over tightened a screw. But I do have a good supply.All in all, for the price, this ‘VESTTIO Double Ended Phillips Cross Slot PH2#2 Two Sided Screwdriver Bit Set’ is a decent deal. The included bit….though all the same…are a good size…a good length..and are super magnetized.

This whole pack hasn't lasted a week putting in deck screws. Tips break stripping the screws.... do not recommend for anything but light work like sheet rock.