RGBZONE 4 Pins Splitter Cable Y-Splitter (Four Way) for 5050 3528 RGB LED Light Strip with 5 Male 4 Pin Plugs

It took a little while to figure these objects out and also required a few videos on the internet but all in all very good and very fun

This is a really simple item and there's not a whole lot that you can say about it if it serves its purpose. It bears mention that it will work for 3-pin 5V or 4-pin 12V. The dimensions are the same between both of those form factors and they physically fit. I have a couple of these splitters and use the same ones on both of the above. It's a good splitter and works fine for me

I could do spider designs in back of my TV

The RGBZONE 4 Pins Splitter Cable Y-Splitter (Four Way) for 5050 3528 RGB LED Light Strip with 5 Male 4 Pin Plugs arrived two days after ordering. I read a lot of comments about the pins being too small, or not fitting properly. I found the pin plugs to actually be a very tight fit into the female connectors, so I am not sure what the issue is with some other replies to this product. The cables appear to be well built, and I look forward to installing them in my computer case with my new Cooler Master MasterFan Pro 120 Air Balance RGB 120mm Silent case fans! Thank you!

I love the product

Recently I have started building my own Schwibbogen as a hobby and using LED strips to light them. As I moved away from simple one level Schwibbogen to multi level Schwibbogen, I needed a way to control each LED strip with the same controller. This splitter works perfectly! I use a bit of shrink wrap tubing over end of each connector and everything is good to go.

I am running (4) 5m strips on each unit. I'm pretty happy with the ability to deliver power to them and they seem to run quite well. No flickering or other odd behavior observed.

I have a reallly strange effect that happens with these splitters. Usually one or more of my extensions is a different color and I’m using either soldered connectors on one application and another snap connectors to connect to the strip. If I set my controller color to blue, The first connector is blue, and the other strips are green. Some colors are the same on all strips as other colors one or more channel is off. It’s a neat effect if you’re expecting it, however seems like a defect in the batches of these I received. In my photo the purple color and the green color is from using one of these splitters. Is it possible the connectors in the splitters I received have a crossed RGB wire? I would like them to work properly...