(3 Sticks) Kirkey Black Roll Bar Padding 1-1/2" to 1-7/8" Tubing -99001

Walking up steps it made the rail cooler. I used black tape to hold it on so it would not slide off

On 1"3/4 Roll cage, the foam was about a 1/4" from fully covering. Each stick was only 35". If you're looking for exactly 36", be aware. Real good, dense foam. Holes were offset towards the side of the cut making the padded side extra thick.

Was a touch small for my 2" dia tubing, but useable

I used this on my ND Miata Hard Dog roll bar with what I believe is a 1.75” diameter. Fit perfect, and I didn’t have to cut as 1 tube was the perfect length for it.

It worked perfectly!

Way overpriced for what it is. It's identical to a pool noodle or pipe insulation. Home Depot sells exactly the same thing intended for pipe insulation for 2.99 for six feet. Don't waste your money on this gimmick.

The tubes split apart easily and fit perfectly over 1.5" tubing. I use them on my race car roll bar. Very simple to cut with a razor blade or scissors. The material is dense but not hard like FIA padding. Perfect for me.

Basically functional. However, nearly all of them had lon, shallow lines of vacant material on them where not enough material had been inserted into the mould or there was a defect in the mould. About 1.5 inches wide by 1/4 in deep by 20" long. This might affect cushioning if it was lined up with the direction of force on impact. I was using them for cushions for carrying kayaks so I kept them. For a roll bar I would pick a higher quality product.

82 camaro