Edge Supply Walnut Wood Veneer Edge banding Pre glued 3/4 X 50' Roll

The media could not be loaded. I purchased this edge veneer for a speaker cabinet project. The rest of the cabinet is finished with raw walnut veneers. This product has a nice, even grain and consistent color. As far as color goes, I’d say it’s about 75% light, so 75% of walnut wood is darker than this edging, and 25% of walnut is lighter. For me, this worked well as the darker parts of the grain were towards the center of my panels, and this worked nicely with the lighter wood toward the outer portions of the panels (see photo). The glue layer is a little bit thick, which led to some white lines that needed to be sanded but it cleaned up nicely. Overall I’m very satisfied with this product for what I paid.

Excellent product- First time I’ve ever tried to refinish my kitchen cabinets. The ones next to the dishwasher, the edges of the cupboards needed to be refinished. I scalped off the old chipped veneer and after a light sanding, measured-off new strips of the new walnut veneer. Using a clothes iron, set to linens, I smoothed over the veneer until it was solidly affixed to the cabinet. I used a dark maple Minwax stain- one solid coat was enough to match the existing espresso walnut cupboard-The whole process took under an hour and the cupboards look brand new!

Really nice veneer. Perfect for 3/4 in walnut plywood. Would buy again for sure on another project.

Great product and easy to use once you know what you're doing. The glue melts quickly under a hot iron and cools fast. Easy to sand smooth and get a flawless edge.If applied properly it can easily look flawless and provide incredibly durability to the edges of plywood. Aesthetics too obviously.Edgebanding with a hot iron takes practice and a few tips like back rolling are essential. Don't expect the banding to stay stuck just by running an iron over it. You have to get the banding in place, run the iron over the length slowly but without burning, then go back with a roller tool or I just use a 3/8" oak dowel and slide it over the banding to press it down to lock in the glue.

Excellente qualité