Polymaker PE01007 PolyLite Filament ABS geruchsarm 1.75mm 1000g Blue 1 pc(s)

Polymaker ABS filaments are incredibly hard to print. Their PLA is beautiful, but definitely not the ABS. Dropping the temperature results in extruder skipping, yet upping the temperature causes upward curling indicative of overheating. There seems to be no "happy medium" here.Each part in the attached image was printed separately as a "repeatability test" (IE: green printed twice and black printed twice) using a VORON 1.8:Green: eSUN ABS+ @ 80mm/s 215CBlack: Polymaker ABS @ 30mm/s 230CI couldn't successfully print a temperature tower either: Above 240C the plastic would "curl up", implying overheating. Below 220C and the extruder would start skipping.

C'était ma première impression avec le ASA et c'était avec une pièce avec du "overhang". Pas génial pour débuter! J'ai dû jouer avec un paquet de paramètres avant de trouver le bon. C'est un plastique très très capricieux, pire que du PETG.Filament, avec la température du hotend à 250c le bed a 80c (bed en Garolite G10), ventilateur à 25% pour le overhang et 10% pour le reste droit de la pièce, le Inner wall flow à 95%, j'ai enfin le resultat escompté!Je suis bien content car se sont des morceaux qui resteront à l'extérieur et qui seront exposés au soleil.

I bought this as a cheaper alternative to Apollo asa. However, I find it a lot harder to print with. It seems very weak as well. Smaller parts with fewer perimeters break really easy. And even in an enclosed printer, I find if i don’t turn the cooling fan on high, the surface finish is not good at all. But I will keep trying because I like their pla

This material, i wish i knew about this a long time ago, this stuff printed with a raft, is flawless, i havent stopped using it since ive tried it, besides the odd petg or nylon print, i highly recomend ventilation as the fumes are toxic and it does smell a bit, i have a hepa air filter system i bought on amazon as well for it, solved the smell & fumes issue. Very very very highly recommended for skilled 3D hobbyists.

I can't believe how well this stuff prints. It stays stuck down, releases easily after cooling, doesn't warp and prints clean even with only 1mm of retraction. Even small points and very thin fingers of material don't warp at all. I have a Flashforge Creator Pro with all metal hotend. 265 degree nozzle temp. 85 on the bed. 50mm/sec speed. .4mm nozzle. Printing on glass with Aquanet hairspray. Thank you Polymaker! I will definately be buying more! Goodbye ABS!I rarely review products unless I would give 6 or more stars. This is one of them.