RGBZONE 10Pcs 5 Pin LED Connectors Solderless Strip to Wire RGBW LED Light Strip Adapter Connection for 10mm Wide RGBW Lights

Above all, each of the contacts are spaced correctly, unlike other products I've reviewed. I had to use these to connect strips that were an inch apart and they saved me. If these people made this available in 2-3cm lengths, that would be cool.

Be gentle with your strips. Peel back any weather coating and do not cut your strips while connected. You'll short the end out.

Clamps well and stays put, I can readjust if I pry hard enough. Only broke one in the process of re-opening. Was working on an LED project. They are slightly bulkier than I hoped but got the job done.

The item description of 10mm wide is misleading. The entire part is 10mm but it only fits 8mm strips. I had to trim 1mm of each side of the strip but fortunately was still able to make it work.I wanted to give this 5 stars because the wire side of the adapter works exceedingly well. The holes for the wire guides perform perfectly and make a solid connection with just a few seconds of work.

Save yourself the frustration and learn to solder. It looks like a no brainer, but very frustrating to use effectively.

I was disappointed with this product based on my intended use. My project is part of a larger Christmas light display. I had hoped to use these connectors to avoid a lot of additional soldering. However, after many hours of trial and error I found that this product is whole inadequate for the purpose I intended. The problem arises from the fact that these connectors don't grip the light strip to keep them from losing connectivity. Thus the slightest pulling caused the connector to come loose. It also seemed that even making a good connection to begin with wasn't always easy. I wound up tossing these connectors and using a soldered connection for this project.If your intended use is to mount your light strip so there is no real tension on the connector it might work ok.

They hold the led strip very tight however the pins are spaced to far apart. I have to bend the 2 outside pins inward to make connections

I see a lot of complaints about this product. Led light strips in general are a tedious process to cut and connect and it doesn't matter which brand you go with. The main secret to any light strip connector is that you need to lift up the pins with either a small screw driver or even a pair of tweezers to reduce the tension on them. Then the light strip slides in perfectly underneath the pins and then when you clamp it down the strip is secured in place. My light strip has 8 segments with these connectors and fell a few times while I was trying to position it and the connectors held tightly.