TechnicqllElectro-Conductive Adhesive Glue for Heating Circuits Printed Circuit Boards 2G

1st the glue didn’t dry very fast. I had to hold it for about 15 min it still wasn’t dry so got some tape to hold the piece in place while it dried. Then it never worked

Super

Utilisé pour réparer le circuit de chauffage d'un panneau électrique chauffant (circuit en pate argentée sur panneau émaillé.La réparation de la rupture avec le liquide fourni à fondu dès sous tension.La réparation avec collage d'une plaquette en cuivre semble tenir après un essai de quelques minutes.A vérifier pour une journée de chauffe avec le thermostat incorporé.

Rien à redire cela à résolu mon problème

Worked like a charm for repairing the degraded conductors on the membrane connector of my IBM Model M.It is not glue. It is paint. When fully dry it is quite friable and has no strength; it could not be used successfully even as weak glue, but as paint it works a treat.It begins to dry very fast, and becomes too thick to brush within a minute or so of dipping the brush, so you have to be a bit quick and use only the tiniest amount at a time. But you only need the tiniest amount anyway, so that's not much of a problem.Do not be alarmed if you still measure a high resistance immediately after putting it on. The resistivity drops slowly over the period after application, and it takes maybe half an hour or so for it to become fully conductive.